Recent content by meldug

I see that I have been calling the expansion vessel a pressure vessel I think abbreviated to EV. However the problem remains,if the EV is u/s what sort of job is it to get it changed? It is located at the rear of the boiler and circular. Thank you

Hi, as the heating and hot water are operating normally except for the excess pressure problem i'm inclined to think that flow and return are ok,but then anything is possible of course. Thanks.

Hi, thanks for reply, Pv is the pressure vessel I have no way of knowing if it is blocked on entry at the moment. Filling loop has not been left on or not shut properly (I am a skilled aircraft and precision fitter familiar with mechanics) The boiler operates normaly except for the excess...

I'm assuming that high pressure going to red sector and dumping water in CH mode is down to a faulty pressure vessel. Can anyone confirm this for me and confirm whether the boiler has to come off the wall as the PV is at the back of the boiler. I checked with pressure gauge and the PV was at 1...

Hi Leccy, fairly sure brushes are ok but will recheck.Where would the thermal fuse be located. Thanks

Machine appears to cycle ie. fills-heats-pump out but no drum action.Have had motor out and changed brushes but no difference. It would appear that either the motor is not getting any supply during the cycle or the motor is u/s. Can anyone throw any light on this problem?