Hi,
I need to cut out a standard sized internal doorway in a 100mm thick concrete block wall that's supporting the floor joists above.
The wall runs from the front to back of the house which is about 5.5m and there's already a door about half a metre in from the front end that I intend to board...
I'll have to post pics tomorrow or over the weekend as I'm back on 12hr shifts for the next 2 days and 2 nights.
Thanks for the help so far, keep it coming please.:)
Yes, I'll probably have to fix one hard up against the RHS of the dishwasher anyway to fix the door panel mechanism properly.
It still won't overcome the support problem though.
I've just checked the front panel adjusters and they only give around 3mm of adjustment so my earlier plan is...
Hi All,
I'm after some advice if possible please?..
I'm half way through a DIY kitchen install (first ever) and I've hit a snag. The guy came to template for the quartz worktops and pointed out a problem where I have an integrated dishwasher that's at the end of a straight run which then has...
Hi,
I'm a newbie here and this is my first post so please be gentle.
I have a new Drayton MA1 mid position valve to replace the current one. The actual valve is broken off the spindle so everything gets hot (CH and HW simultaneously)
I was fairly confident about changing this over but...