h..... I want to change a washer on my tap. I have takenth grub screw out of the side and epexcted to pull the tap straight out, but it will not come out .If there is a ceramic valve in will it affect it...
hi.... i want replace the washer on my kitchen hot water mixer tap but there isn't an islation vave. the tap is gravity fed not a lot of water comes out when turned on (continentel taps and only run slowly or so i'm told ) would it be possible to change the washer without running the hot water...
I have stripped down the handle and cartridge on my mira 88 gem shower to put new o rings in. On reassembling I have lost the plot how to arrange the cartridge / grey locking seal / shower handle etc. does anyone know in which order they are put back together. Should have taken a photo dooooh...
Hi... there are some pin holes in the spout of my kitchen tap. I've tried to locate one but it must be obsolete. It's a Rangemaster tap. Is it possible to have it re - lined or to seal it somehow, or if anyone knows where I can get one. Thanks
sorry for the delay.....unfortunately the bath is tiled all around. I cant get to to waste trap or the overflow. That must be why the plumber put a push in waste top.I was thinking of buying a threaded waste top and cutting the threads offf and just leaving a lip to push into the waste drain hole.
Hi.... can anyone tell me where I can buy a bath waste top like this. The top flange is one and three quarter inches and the push in part is one and a half inches there isn't any thread it just pushes into the top of the waste pipe.
Cheers mickcoulson
hi..... Ihave a small desk fan that can be dismantelled. I want to take it abroad to try instead of buying air conditioning. What i want to know is will it be ok to use with a one gang extension lead. The power cable for the fan is two core. I use it at home no problem...