Mr Grich - fantastic detective work! I can see on the leaflet with the E-Bay hinge the 'HAPS' logo, so we are very close! Unfortunately nothing in the HAPS line has the square plastic cap, although it looks as if all the other bits on the p100 are the same. Many thanks. I will chase up Mila...
Waiting for final confirmation from helpful tech at Mila (and fingers crossed, installation instructions etc!) but it does appear to be an (obsolete) 3-DL.
Thanks, Rob, yes , I applied my usual high-quality work to the repair.............
Sistuation has now improved and a replacement liner located, so done with thread - and thus will NOT be ordering your set for Xmas....
I have a Laufen 'Galley' cistern which has a split in the plastic 'condensation liner' inside the cistern, causing a leak into the innards. Tried fibreglass, but it still leaks. It is a 'discontinued' cistern and it appears a replacement liner is a rare beast judging by the response from Davroc...
This is with the motor on the bench. I can see no way to move the block. The problem I have is that only the top part of the yellow block (the part with the wires passing through) came off which I suspect is bad news. I cannot find any way to release the lower main part of the yellow block.
Grateful for expert help here!
Trying to replace these - there is a multi-pin yellow connector block which stops my removing one of the brushes. It looks as if I need to remove the block, but I am reluctant to put too much force on it - how do I get the brush out?
Need to remove to fit new door seal. Anyone know how to do it? I have removed all screws at the front but it will not budge. Does the top need to come off?