Many Thanks - may i clarify a couple of things!?
This is a 1 way pull cord switch.
Going into the switch (from the light fixture) is the yellow (switched live) and red (permenant live) and the wires coming out (to the fan) are the yellow (switched live) and blue (neutral)?
May be being...
There is no existing switch. I am trying to break the connection between the light fitting and the fan. The light switch is still there i am trying to added an additional switch to turn on the fan only.
YELLOW is SWITCHED LIVE sorry not RED. Its a thick grey cable...
The purpose of having...
At present when i turn my bathroom light on the ceiling mounted extractor fan turns on. When turned on, the light switch powers the fixture which then powers the fan.
I am now installing a pull cord switch between the fan and the light fixture to allow the fan to be used when required, not...
1. I have used powdered ARTEX and its superb but it’s the hassle of mixing it up I suppose! Although I am using SLATE tiles I should look for an adhesive/grout suitable for PORCELAIN tiles?? Homebase make the ready mix – would that not be sutiable?
2. I was thinking that where there is a gap...
Hi there,
I am about to tile a kitchen floor with 10cm slate tiles. The units have recently been fitted.
Couple of questions.
1. The floor has vinyl (marley) tiles stuck down onto concrete. I have tried using a heat gun and a hammer & tough scraper but with no joy. They chip (as...