Hi Guys
Don't know if this has been covered before.
Can you please help with advice?
I wanted to know if there is any building regulations in commercial building that say about obstructing D.B
Thanks
Hi,
Im replacing my old HoneyWell T40 with a Honeywell CMT907A Battery powered thermostat. The T40 has 4 wires (Earth, live and two neutral from what i can make out) where the CMT907A only needs two.
Ok I Have
RED
blue
yellow
earth.
What cable on were on CMT907A
Hi all could I get advice me on the below
whats the differents between led constant current driver and led constant voltage driver.
I have led strips lights on a constant voltage driver, but when it's turned on it blinks every 5 ish min...
Any one help me please
I have a Saunier Duval XEON 30HE Condensing boiler Open vent system.
OSO unvented tank.
The water works fine but the heating only works if hot water is also ON at the same time.
On the Heating side when I bleed the RADs water come out but lots of air in all RADS. I have bleed all Rads...
Help needed Again :cry:
I have a LED Strip light which will be on a 13amp plug top plug in to wall socket. But the Socket to difficult to acess on a day to day
So I was thinking to put a 1way switch to turn the led's on and off from it
HOW DO I WIRE IT UP :?
Help Me please Guys
In my porch i have a ceiling rose lamp and wall switch.
I would like to put in a ceiling PIr but can over ride it with the switch.
step by step please and what cables go were,
Thanks Guys :P