Recent content by Nitell

  1. N

    Drill/Cut hole in Cooker Hood chimney

    Sorry, I meant cutting off Cooker Hood plug, and joining with length of cable and plug.
  2. N

    Drill/Cut hole in Cooker Hood chimney

    Hi. I have just installed a Cooker Hood. It seems the manufacturers did not think to design a proper route for the cable & plug. I will need either to run the cable to the top of the two chimneys, fit a FCU to plug in, then the rig a connection to the 13A socket at the worktop. OR drill and...
  3. N

    Suck Out Water Before disconnection

    Hi, I fitted 2 Kitchen taps a few days ago, using existing Fibre washer Tap Connectors. I allowed for 'weeping' at the Fibre washers. One is fine, not 'weeping' anymore. The other one has not 'sealed', despite constant checking and gradual tightening. I now consider replacing a section of...
  4. N

    Concrete Steps

    Hi, I plan to build external concrete steps (3 x steps). The ground area will be approximately 84 X 84 centimetres. How deep should the foundation be, please?. Thank you.
  5. N

    Fitting new WC

    Dilalio mentioned whether the Flexible hose will do rather than the Offset. So, I have provided a drawing to illustrate the present layout. Height of the outlet from the WC is approximately 140 from floor level. Height of Inlet to the Soil Stack is approximately 95mm from floor level. The...
  6. N

    Fitting new WC

    I am not a plumber, so I am wondering if using the Offset, and the distance between the outlet and the inlet is sufficient to allow good flushing. Or, if I would need a longer 'run'. Thank you.
  7. N

    Fitting new WC

    Hello guys, Using a 60mm Eccentric Offset Pan Connector + extension, I am fitting a new WC Pan. The height of the inlet to the soil stack is 95mm above floor level. The height of the WC outlet above floor level is 140mm. The distance between the two, offset and extension, when fully...
  8. N

    Set TV to watch Freeview (& Other Free Channels) Only

    Accelerator, you were not compelled to answer my question. You could have ignored it. It is only because (on the internet) I have read so many opinions, I was only seeking advice on this forum. To everyone else. Thank you.
  9. N

    Set TV to watch Freeview (& Other Free Channels) Only

    Hi, Medion TV I do not want to buy TV Licence. I want to set up to watch only Freeview & other Free channels. However, I have noticed this > Setup > Once complete, your TV will display available Freeview channels, including BBC, ITV, Channel 4, and Channel 5. But, BBC, ITV etc. are not...
  10. N

    Radiator valve Caps

    Great. Thank you. Will get those.
  11. N

    Radiator valve Caps

    Hi, I have found it somewhat difficult to get radiator valve caps. Please see photos. Can anyone say where I may get any of the type shown, please?. Thank you.
  12. N

    Fitting Carpet Grippers On Concrete

    Hi, I am fitting Carpet Grippers (Royale Carpet Grippers) in a number of rooms. I need to fit Grippers where there are concrete hearths, but I am unsure of the best secure way to do it. Soudal 'Grip All' is supposed to provide a strong bond on concrete, but I am uncertain. Not keen on doing...
  13. N

    Carpet a Bit Short

    Hello guys, I have rooms where skirting board to skirting board is 5.07 Metres and 4.955Metres. Buying Online I can only see two Widths, 4 and 5 Metres. Any suggestions, please?. Thank you.
  14. N

    Fitting Quadrant/Carpet Grippers/Carpet

    Thank you. Gap between skirting board and floor. Crazydaze: In that case, I may need to fit a small strip of timber along that area, say about 20 x 20mm or 25 x 20mm.
  15. N

    Fitting Quadrant/Carpet Grippers/Carpet

    Hi, Due to the gap between skirting board one one side of the room, I have fitted a 19mm Quadrant. Now, I have begun to wonder if fitting carpet grippers next to the quadrant, I can still secure the carpet in that area. I have not ordered the carpet as yet. Should you feel I have done things...
Back
Top