Recent content by not so warm

Ok I've taken the live feed direct from the mains supply terminal below the terminals x10 as it was neater and closer. Thanks guys it works a treat. :mrgreen: All in all I'm very impressed, I should've done it years ago, it as also recommended by the British gas engineer as well. I short...

I must admit I prefer to keep the sunvic as it has been extremely reliable, Just setting the Ch to off, great So I'll link the two L's and then link A.

I have a well maintained WB240. It currently has a sunvic select 207 digital timer etc. Wired in as follows: N= N blue L= L brown T1= blank (hw off) T2= blank (ch off) T3= black taped (hw on) T4= black (ch on) X10 panel on boiler wiring: 1=black (ch on) 2=black taped (hw on) 3=...

I ve been on here loads of times, posted not so much as the first couple of times Ive posted and searched I was presented with all the info needed, TOP NOTCH. I have a worcester Bosch 240 combi with a normal drayton digital timer etc, But the wife wants a modern Wireless Clock/Thermostat...

I have a Worcester Bosch 240 which with the help of you guys replaced the diverter parts many times etc etc. The pressure is above 3Bar and I have replaced the PRV. Water is passing out of the charged 10ltr Pressure vessel so it needs replacing. But as Im a cheap skate and seen Rogue Traders...

http://www.smps.us/tools.html do trials and freeware

Just had triton out to look at the unit and they have fitted a bent bit of plastic on the microswitch. now we have a working shower.

you can play console games using a modfied console running on XLINK KAI. via internet and its free, apart from modding your console.

we have a linksys wrt54gs V4, we installed a well known 3rd party Firmware Version: v4.71.1, Hyperwrt 2.1b1 + Thibor15c, and boosted the Transmit Power from default 50% to 100%. then did a site survey and found 3 others on channel 2 so moved ours to channel 13. Planning to buy the linksys...

You need this, http://www.security-forums.com/viewtopic.php?t=23102 Extract taken from site: updated: June 2006 Hi everybody, Because so many of you need this I decided to publish here the whole story. 1. Introduction. As you may know, IBM ThinkPad uses a small eeprom...

normally a sign of either binding or needing a quick clean with a air line. to tell if binding try depressing the peddle a little (not so it slows the car) to see if the noise gos away. Cleaning because as you are using the brakes, dust particles gets trapped in and around that area.

Not true regarding hot weather and sitting in traffic. I have a 1959 VW Karmann Ghia with a 1671 tp. ours will easily do 90+ on a motorway. Without signs of overheating, and sitting in traffic isnt a problem. it depends on the condition of the engine. Make sure the heating is ok, and the...

battery box's rust out, sills, frame heads can be expensive. What year are you after?. floors behind seats rust out. loads of replacement panels around and very cheap £20 half a floor

cheers chap, plumbworld , but yeah wandering drill bit can make big mess of a nice bath. any ideas regarding the bath grip fitting, as its a item which can subjected to a amount of force.

I have the same problem with a topaz 100si, We have low pressure round here. 1, try the filter. 2, fill a measured container of water whilst using a stop watch to gauge the amount of flow your getting. 3, ring your water company to get them to do a pressure test. triton showers...