Recent content by nyc6699

Many thanks everyone and very much appreciated.

Hi all, Can you clarify the following for me please for a single channel hive connection into the boiler. I’ve read similar posts but not quite the same set up. Picture 1 is inside the boiler. Picture 2 is the single channel. Is it LS on the boiler to 1 (common) on the hive and LR to 3...

Ideal. Much appreciated Cheers

Sorry just to confirm. Remove the current wires in CN5 and replace with 1 and 3. Does it matter which way they go in CN5. Noted re NOT linking. Many thanks

Hi all, Can someone please check my understanding of a hive single to my Vokera Excell 25 boiler please. Image 1 is the boiler PCB and CN5 has the current thermostat and controller fitted. Image 2 is the standard hive single channel. My thoughts are as follows N and L permanent on the hive...

Great. Thanks again

Hi all, I have had a complete mind block. In reference to the above, I wired in hive as per instructions by CBW and it’s working perfectly, but I didn’t route it through a 3 amp switched spur. Do I need to do that or is it perfectly fine coming direct from the boiler? Thanks all.

Fantastic thanks very much. When linking (heating on) back to LR on the PCB, would that be into the heating LR or hot water LR or is it into the heating LR and then add a link / bridge to the hot water LR. Thanks again.

Hi all, I’m not seeing exactly what I need so hoping someone can confirm for me please. Hive mini single channel diagram and internal board of Worcester Greenstar combo boiler attached. Can someone please confirm exact wiring as the board doesn’t have the usual LS, NS, etc. All help very much...

Ok thanks for that. Will concentrate on the boiler. Cheers

Hi and yes single channel installed Thanks

Hi all, Looking to see if anyone has had a similar experience and how it was resolved. Installed Hive Thermostat about 6 months ago to my combi bolier. (Gloworm Extramax). All works fine but every now and then it defaults the boiler to heating only, hence no hot water. It’s an easy fix, as I...

Evening, Thought I would share my findings in case it helps others. As a last resort, I found on the PCB a tiny micro switch, so switched it off, changed the settings to 0 and all now working. Thanks very much for everyone’s help. Really appreciated

Ok worth a double check. Cheers

Just thinking as a last resort re this issue. Do I need to link hive live to the common and then wire up as previously mentioned. Do you think that’s the issue. Can’t see any other option.