Recent content by p3dro

I would happily forsake an easy answer for oh I don’t know, a relevant one…! perhaps addressing what was actually asked in the first place or just skipping sharing your perfectly legitimate but ultimately unhelpful opinion altogether. No you’re right, as the thread illustrates, this is much better.

I can’t see why asking A.I. is so popular these days.

Thanks for sharing.

Are you saying it’s failed?

I don’t recall it ever being that dark to be honest.

Hello all, Around a year ago my garage roof was re-done. It was organised by the neighbour (joined garages) as he had a bad leak and the new roof consisted of osb boards with "liquid rubber and reinforcing fibre mat". I saw some of what was happening - the fibre was rolled out and the liquid...

I measured 8 ltrs per minute! Did it twice at different times to make sure... P

Thanks again Terry....I'm off to find a bucket! P

Hi Terry, thanks very much for your reply! We moved in, in mid 2019. It was not serviced in 2018 but was in 2017 apparently according to the seller's paperwork (gas safety cert - it was a rental before we bought) We had it serviced in Jan 2020. It is due it's annual service this month. Is there...

Hi all, Last year around March/April we had our upstairs bathroom re-fitted. We had a new shower with mixer tap, a new sink with mixer tap and a new bath with mixer tap, plumbed in that order / sequence. All has been working perfectly until about a week ago.... We started noticing a single...

thanks for your answer ktuludays. in answer to your question the drain cock is on a ground floor rad valve. the filling loop is present and works well. got 3 other rads upstairs so better get a bigger bucket. would you drain the upstairs rads individually first (bit easier?) then cut the pipe...

hello all, i took down a wall separating the wc from the bathroom which had a rad on it. i'd like to relocate the rad to one of the other walls in the bathroom. once i know the location of the new rad i need to route new pipe to join to the existing pipes under the floorboards. if i cut off the...

thanks for your reply. thing is, if i put the temp up on the salus thermostat to 25 for example it signals the boiler and the boilers kicks in no problem, so i think that side of it is fine - i just think the temp readings on the thermostat are rubbish! my assumption is, and i may be going...

Hello all, I had a new boiler installed 1 year ago (WB Greenstar Si Compact) and it's great but I'm convinced the SALUS RT500RF the fitter also installed is wildly inaccurate. As I type this sitting in my kitchen the Boiler is off because the Salus says the temp is 18 degrees. It's bloody...

Hi, did you find out? I need some of this beading too... P