Recent content by Pangloss

We are having our 1990 built bungalow extended and renovated. The new 150mm concrete subfloor was laid in October. The existing floor was stripped back to the concrete subfloor. The subfloor was lined with VCL with 75mm Celotex on the new subfloor and 40mm on the existing. Underfloor...

Thanks everyone for your responses. The roofing company came back. They replaced the broken tiles, and the valley. They fitted new permeable felt over the old felt. They re-bedded the tiles on either side of the valley. I paid a contribution to the work because it was not clear how much...

In June 2018 I noticed staining to the bedroom ceiling due to a leak, there was also mortar coming out of the roof valleys and cracked verges. I also had cracked verges on the garage roof. In August 2018 I had the ridge tiles and valleys repointed on the house roof. I also had some work done to...

Thanks, that's perfect. The head had 2 year warranty, I will check whether I can claim.

Just come back from work. Thanks for all the comments. I have tried a fix by turning hot water to continuous and moving the valve to the test position. Now the pipe out of Port A is hot and my radiators are heating up. Will it be safe to leave it like that for a few hours or am a likely to...

Thanks Mick but the 3 port valve is behaving OK these days. The boiler indicator turns green and the boiler ignites if I turn up the temperature on the small thermostat that's attached to the hot water cylinder. The boiler doesn't repond at all when I turn up the Honeywll thermostat. I was...

Hello, my boiler is a Potterton Supprima. It's about 19 years old. The original PCB was replaced some time ago by a Siemens one. With heating demand from the thermostat, the pcb indicator light is steady orange, which means the pcb is not receiving a heating demand. I wanted to check whether...

Thanks all. Lesson learned and cubicle completely re_sealed.

Back in May I re-sealed the gap between the tray and the tiles using Dow-Corning bathroom sealant. I also replaced the grouting in the corners of the shower cubicle using an epoxy grout. As you can see from the images the grouting has cracked in one of the corners allowing water to get behind...

I realise it's been some time but I haven't spent much time on DIY recently. As the latest image shows, I have removed most of the Artex over the jointing tape. As you can see, there is about 25mm at the bottom of the image where there is either no tape or a longitudinal split in it. The...

I have looked around the forum but I can't find a similar case to mine. I caused a gate valve to leak in the airing cupboard. A small amount of water leaked before I could get the valve repaired. The water flowed to an old crack in the ceiling where it dripped through the artex causing a...

Update: I found a lot of advice about sealing and grouting on the internet and on this forum. The boss insisted I used grout between the tiles in the corner. According to Mapei's data sheet their waterproof fix and grout is acrylic based so maybe it will have some flexibility. Having read all...

Update: when I removed the sealant the back of it was moist at locations all around the tray. Any suggestions as to how this might have happened?

Indeed Hugh, over the years I have discovered so many things the builders have done that even as an amateur, I would have been ashamed of. If ever I buy another new build I will try to find an experienced tradesman to look at the workmanship before I sign off on the purchase.

The shower cubicle in the attached was installed by the builders in 97. After a while the sealant became stained so 6 years ago I removed it and re-sealed using a generic type. When removing the sealant some of the grout in the corners came out with it so I had the "brilliant" idea of...