Recent content by Papion

Hi Five days ago, my wife move the 3 fan tailed gold fishes from outside to a smaller indoor tank ( 1 ft by 1.5 ft x 1 ft deep)) because of the zero degree C freezing weather. they were ok last night but not eating a lot. Now one of 5 year old is not moving ( presumably death), the other two...

If it has an Air Pressure Switch, try blowing into it a few time to reset it. or it could be a certain sensor (switch) trip it off. Try asking for a servicing manual to troubleshoot it.

Confucious said, " once there are 3 wise men wanna buy a table, one would buy the cheapest, the other would choose the biggest, the last one would want extra put on ----an extra leg."

The prize you can have is the old pump and probably a drink from Mougly

I was told there was a 5 volts potential difference between the ground and the neutral wires. A drop of water on them would trigger RCB to trip off. I have a scenario when I accidentaly drip water from the CH drain ( some clever builder fitted it just above the boiler) onto a terminal...

If you are sure it is translated from Chinese, then send me the chinese instruction, I could translat it to you.

The poor mougly has no electric power to power up his PC for a reply

The web site link http://www.salamander-engineering.co.uk/technicalcentre/faq/faq.htm#softener also emphasizes that The noise created by the scale in the boiler is extremely noisy for a 7 yrs old house in Stansted we rented many years back. The recommendation was to have a new boiler...

That is interesting. I have the same gas fire in my lounge as yours (a real flame gas fire with lava rock). I had a terrecotal cap with 4 rows of vetilated slots all around installed by a builder( not corgi ). http://www.thechimneypotshop.com/toppage2.htm I went to build center and...

If the fan does not run, the boiler would not fire. Can you hear the fan running after a few reset when the boiler works.

Next she is going to swap you for

I did it with wire brush bent at 90 degree which very effectively brushed off most of the deposit. Because of several years of neglet and no servicing, there are numerous trapped in between the fins which I used 18 gauges wire to shove some off. It is difficult to clean them all as the...

What is the best way and liquid spray to remove in situ the lumps of sandy deposit in between the fins of an aluminium Heat Exchanger of a fanned flue boiler. I tried sulphuric acid (brick cleaner), vinegar, methylated spirit on the samples to no avail The HE is difficult to come out...

Hi, Agile I blew into APS 4 times when it was off, then restarted the boiler. You mentioned that I believed the APS was stuck open. By blowing into it reset the switch. From the manual, APS is powered from the PCB in series to flue stat, dry fire stat and gas valve. If...

I have cleaned the burner and heat exchanger but fault remained the same. Then I blew into the air pressure sensor which had an outlet exposed to ambient pressure and it fired up. Now my CH is working normally and my New Year is not spoiled. Thanks a lot for all your suggestions. I am very...