Hi All
Dreaded 168 error
Hot water on demand is fine and works all day :)
Time of year again when central heating is put back into use and all is not well
With the CH dial set to 50 to 60 degrees the boiler will kick in when the wall thermostat demands it but will then cut out after a few...
I Had a gas meter replaced some years ago and the meter read 2 units at start
Then they came and read it after 3 months and i received a bill of £2000
I Tried to tell them that a)It was not a chip shop b) Looking at my previous 3 years bills you can see i do not use that much gas
For...
No Problem
Just modify and i can use either compresion fit or pushfit :!:
You can make life as easy or as hard as you like, well sometimes
And pushfits were made to make life easy and remove you of money
so
You would prefer (Better performance) to rip out Isolate Valve 3 Stick in the ABV in it place
I'm easy and you guys have done it more often than me
All i have to do is get 3 elbows and reducer to bring it down to 15mm
The only reason i chose that position was looking at boiler...
It is getting late
Yes i was going to slip in the auto by pass after the pump as the diagram shows then next week slip in a 3 port valve so i can eventually get some control with what i want
I Hope doing as the diagram and closing valve 3 should take me to the next level of this project...
Sorry Dan you have lost me now
You obviously don't mean the Automatic bypass valve :?:
Feed me a little more info and i might just catch up with you :wink:
Yes but no but :roll:
Local merchants did not have one in stock but did have right angled version which means a bit of pipe work but nothing serious
I'm easy all the info i find around shows it fitted just after the pump
Thinking as it is 22mm go with the flow instead of adapting to...
Dan
Don't care what the locals say your a good egg :D
In brief does port "A" go to the top pipe feed to the Hot water storage or to the bottom pipe
Plus do i have to stop using one of the 2 pipes as it looks like it defeats the object of the 3 way valve
I do plan to fit the...