Lee, brilliant post I’ve just followed your example and cured a problem umpteen people have commented on and none were able to provide a real answer to apart from throw more money and parts at it, which is not a fix but a mere hope and guess approach, which I find very hard to go along with. Was...
Thanks very much for all your input, it is all taken on board and I will as you suggest go with the metal ones as I consider this the appropriate action. Once again thank you all for your help it’s really appreciated
Thanks for your prompt reply, I consider myself very conscientious about my properties and the tenants wellfair, but, why earth are they still selling plastic cu if they are not deemed safe for tenants then they are not safe for anyone. As you rightly point out it is advised where problems could...
I am in the process of having electric certificates carried out on rental properties. The quote has stated that all plastic consumer units must be changed for metal enclosures. Ive read the electrical regs they do not state that they must be changed, and plastic consumer units are still being...
I have a rental property that is now required to have co alarm in every room where combustible devices are present. The combi boiler is installed in an airing cupboard which is 1m x 1m x ceiling height so it would appear not within rules to install it in this area as outside the 1-3 metre limit...
Just a quick note, thank you very much spatkymarka you were perfectly right with your advice regarding the ET link, spot on thanks for all that your help was most appreciated
Thanks for that sparkymarka, that’s cleared that point, I will check the other points tomorrow and update, thanks for your help it’s really appreciated
Thanks very much for your prompt reply, firstly I can seem to test it by inputting say 96 etc no problems, it’s just when I try and set a zone to enabled it only shows the first digit and doesn’t show say 21. When I perform a test display everything lights up but the segment only shows 18 when I...
Please excuse my ignorance in this aspect but I hope the pros on here can help. I have a scantronic 9100 which I saved from another property, I am trying to set it up from the install manual, well it does ‘seem’ to work somewhat. I am trying it on the bench with zone/tampers linked out and a PIR...