Recent content by phazed

Hi there, I'm about to have the floor of my garage conversion tiled with underfloor heating and was looking for an idea of what I should be paying. The room is 5m x 3m, no awkward cuts. 15sq meters. Tiles are ceramic 400x200mm. I am suppling the Tiles, underfloor heating kit and i've...

That's a very good point, balls!

True, but i was thinking of doing away with the supplied fixing bracket, slapping on a couple of 15mm x 3/4" Male Iron's onto the protruding 15mm inlet pipes, and hiding all the nasies behing the fascia plate. Not the prettiest, but assumed it's feasible?

Cheers, seco. Pesky regulations :wink: I did find this with 60mm centres; http://www.qssupplies.co.uk/bathroom-furniture-shower-taps/9224.htm# May be a really daft question, but apart from looking a little odd, would it function correctly if mounted horizontally, rather than vertically?

Tell me about it! I know 150mm is pretty much standard these days, just wondered if anybody knew an obscure manufacturer who still made them with 60mm centre. I did consider a power shower, but subsequently thought I may run into difficulties as I'm not Part P registered, technically I'd have...

Hey folks, As the title says, I need to replace a a mixer shower that has packed up. I have no idea of the make or model as there are no markings whatsoever. Uploaded a couple of photos, if anybody has any ideas. What I can say, is that it's has 60mm centres on the hot and cold...

Hey folks, Just finished descaling my unvented cylinder, which were attrociously scaled up after only 3 years! So, i'm looking to install a softener at the mains point of entry into the house. I'm baffled by the whole plethora or different types availble, so any advice on a decent...

Many thanks for all the replies guys. Borrowed a power flush machine from a guy i know in the trade, ran fernox through the cylinder for about 3 hours, drained, repeat the process, flushed the cylinder a couple of times and voila! Back the the pressure I had when I first bought the house...

Thanks for the replies Boilerman & dangermouse..... With regard strainer, it's definately been checked twice, and it's clean. The PRV, the engineer took it off, did a visual inspection, which he said looked ok, didn't appear to be sticking, but he didn't actually have another one at hand to...

Hey folks, first post, come to pick some brains! I've had a problem with hot water flow for a while, which has slowly degraded to the point that it takes half hour to run a bath. I have a Range Tribune HE Cylinder supplied by a standard gas boiler. My house is only 4 years old, therefor...