Recent content by poolielad

Yes mate, cladding is correct lol...

Is there some sort of overhang i could buy and add it to stop rain hitting it??

Its just a sloping roof with 100 x 50mm joist covered with osb boards then felted.... I am grateful for all the replies, but what will the easiest solution be, (remember I am anovice DIYer..lol

I dont expect ot to be like a room in the house, I am not a builder, its just somewhere to chill out!!!

And please could someone give me a link to the breathable membrane which I would need? And is it just a matter of putting membrane over the frame, then putting the cladding back on, or do i need to leave a gap between membrane and cladding?? i,e do I need any battens between membane and...

Is that really the only option??

Ah right, could i not do that from the inside?? Or would a water proof sealer on the cladding solve the issue?? And thank you for the reply.

Could this cladding just need sealing with some sort of wood sealer???

Hi, I am doing a little home project, I am just a general diyer> I live on a end terrace house and i have a side patio which i am covering in to use as a extra little addon on room to the house. I have done the roof (no issue there). I have cladded the outside wall with this stuff, Tanalised...

I have just done a rev test while parked up, over 4000rpm and no shaking at all.

No rumbling noise mate and nothing from clutch either.... soon as i take my off accelerator, whether to change gear or slow down it stops.

I have the above car. The problem is when I am accelerating the car starts to shake, its ok till I get to 50mph, but when I accelorate more it starts to shake, I thought it was wheel balancing, but had all 4 done and still the same...... Soon as I take my foot off the accelerator, no matter what...

Looking at that it looks like it’s been soldered on so I dare not twist it incase I end up with a leak

Thank you