Recent content by ClaphamLondon90

It's a new wall, no water source, soil, downpipes. Believe they did it in the same day. Screwdriver test, in the section with the holes in, the mortar comes out, the rest of the wall the mortar is very strong, just appears to be that section, so about 3 rows of mortar affected.

What happened to this wall? And can it be fixed without rebuilding it? It's not supporting anything, just used to block off a passage but it doesn't look right to me...

Update: It is working, I was just being impatient waiting for it to fireup. Left it for a good 15 mins and came back.

Tried that albeit, without the Nest thermostat being linked using the existing Honeywell wirings from T1+2 on both ends. I have the Heatlink wired L-L, N-N, COM-COM, ON-ON. Turning thermostat on the boiler pump starts going, radiator symbol flashes, but it doesn't fire to heat. Fires to heat...

Honeywell t3630, picture of wiring attached

Have a baxi duotec 28. Drayton LP711 is wired in and I want to swap in the Nest. N+L and 1(COM)+3(ON) is wired on the LP711. Along with a link to the Honeywell controller. So on the Nest wire N+L the same Disconnect the Honeywell controller by removing the link between the blue+grey cable...

All 4 lights are flashing on the bottom row, start/pause flashing bottom right, and 4 lights on the right including the spin, dry, end and keylock lights permanently on Checked the water inlet, drain pipe and the collector at the bottom. I'm a tenant so waiting on landlord/agent to get in...

Hi Muggles, I just measured it at the shower 4.5L/min, from the hot water tap it is 7L/min

To start with apologies for any stupidity with this post it is my first! Now...having recently moved into a new property the bathroom shower has poor pressure. It is a Mira Electric Advance ATL Flex 9KW At the mains the pressure is good so either I presume the shower is just bad or there is a...