Recent content by Pseudomax

Thank you ... I recognise you are doing this in spare time... so I will give your time respect! When the rest of the family are not in bed I will try your suggestions and be more specific ...

I also get 'Door Now Open...' when I use my fob with the keypad? No doors are open and I just want the alarm arm (no other action ... but on a timed exit)

Hi, I have literally just opened a new thread asking the same thing (with some other setup questions). Please can you explain where in Wintex to find the 'local arming / disarming for code'? Apologies, I am sure it is obvious for most!!

Hi I recently resurrected a thread https://www.diynot.com/diy/threads/texecom-premier-elite-dreaded-no-ats-available.552302/page-3#post-4885561 as I had a similar problem. Per that thread I had no success in fixing the problem and asked a professional to come and re-programme. They visited last...

I will try again later... but I am pretty sure I have done this already! (without loosing the error measage)

Hi secureiam, thank you for the reply!! Regarding the "bell not being named properly" ... I was more just adding context to why I started playing with the settings (I was unable to arm the system ... and the only information I had was ZONE018 was preventing this ... but that is not an issue...

I have a: Premier Elite 48-W LS1 868MHz Actually, everything was working fine, but I changed the batteries (and additionally the external siren was not properly named by the actual installer) and because of this at some point the Connect App stopped working. All my 'fiddling' with the settings...

Hi, I hope I can resurrect this thread as I have (had) the same problem as Speedbird979... I can confirm that swapping the COM1 & COM2 port options and the returning them to normal also fixed my "No ATS" available problem. Actually, I seemed to have an "ATS Path Fault" but on Wintex there were...

Hi Woody Thanks for the response ... and glad I was right section first time! Can I just check ... if no cavity trays then it should still be ok? There is a membrane that was added about 1-2 blocks up from the steels that directs rain away from the internal wall (the membrane is attached to...

Hi I am new to the forum, so please excuse any posting in the wrong place! My questions/advice needed relate to an extension that I am finishing off. I have 2 RSJ's spanning about 3m and the edge of them is exposed to the outside. The whole extension will be rendered with a monocouche render...