Recent content by RainbowWrighty

Thanks blup, I'll give it a go without the mesh (y)

Hi, I need to fix up this access hole from a recent electrical job I had done. I've got a bag of Gyproc EasiFill 60, but I was wondering if I also needed mesh tape to cover it first or for the size of the hole it is, will the EasiFill on its own be sufficient to patch it up? Thanks RW

Hi, Sorry if this sounds like a stupid question, but... Can a standard door be cut down to size to become an understairs cupboard door (600mmx1200mm)? Something like this: https://www.wickes.co.uk/Wickes-Chester-White-Grained-Moulded-4-Panel-Internal-Door---1981-x-610mm/p/165801 Thanks RW

Could do, hadn't thought of that.

Thanks. CT1 it is then. There's a few other job I can use that with.

Hi Currently prepping the stairs to install glass balustrades. The previous plywood panels were installed into the groove as shown in the pics. The groove is about 10mm deep and 7mm wide. I plan to fill that with a drillable wood filler and then install clamps for glass balustrades. What...

Did you complete this job? I'm about to start the same job in my house. Would to hear how your project went. RW

Hi I need to repair a floor tile in our kitchen - see pic attached. The broken part of the tile will lift out OK, but as it's only a small repair, can I use an alternative to tile adhesive? Just trying to avoid having to buy tile adhesive and have loads left over. Thanks RW

Hi, The chain on my electric chainsaw needs sharpening. I've got a Dremel-type tool, but what diameter of sharpening stone will I need to sharpen the blade? The chain specification is below: Pitch: 3/8" / 9.525mm Gauge: 0.043" / 1.1mm Drive links: 40 Bar Size: 10" / 25cm I was planning to...

Update: I replaced the flexi pipes and ISO valves at the weekend with copper pipe work and the towel radiator now gets roasting hot. The wife is happy - no more cold bathroom. Thanks for the replies!

Thanks for the replies.

Yes there is a slight kink on closer inspection. I'll see if I can fix that.

Fitted by a general builder who did the bathroom refit! What pipes and isolation valves would you recommend?

I've got a problem towel rail in the house and I've been scratching my head what the problem might be. The towel rail only gets luke warm at best and there are no colder or warmer patches on the rail itself. All of the other radiators in the house are roasting. I've checked for an air lock by...

LOL! :D I *knew* I'd get at least one comment on the net curtains! #posh :wink: