Recent content by richchad

  1. R

    Siemens SN66T052GB Dishwasher Leak

    Thanks for the info, I actually found the screws holding the sump had come loose and when tightened from inside the dishwasher the leak stopped, fingers crossed it will be okay for a while. I will keep your post in mind in case I have further problems, thanks again.
  2. R

    Siemens SN66T052GB Dishwasher Leak

    I have had the usual E15 leak code show and after investigating by looking at bottom of washer after removing lower front panel I can see water dripping from the seal between the steel and plastic filter and pump housing. Can I buy a replacement seal and is it easy to replace? The machine is...
  3. R

    ACL Lifestyle Valve switch problem

    Thanks for your reply oldbuffer, unfortunately the valve is located almost at floor level on the ground floor so most of system will be drained apart underfloor pipework I guess. Okay so the locking lever would work if I have annex heating on with main house. Did you see my earlier question of...
  4. R

    ACL Lifestyle Valve switch problem

    Okay so no replies to my question which was a bit complicated maybe... Perhaps another option for me is to keep the valve open all the time, I understand there is a lock lever on the valve.. Which is the best way to use this option as I have read the valve closes back to normal when powered...
  5. R

    ACL Lifestyle Valve switch problem

    Unfortunately it is a unvented Megaflow system so guess that means a full drain... Didn't really want to do this now we need heating everyday, was wondering if I could do something temporary like this... As it is a secondary circuit to heat a rarely used annex, I can get heat in there when the...
  6. R

    ACL Lifestyle Valve switch problem

    Okay, that was what I thought, thanks.
  7. R

    ACL Lifestyle Valve switch problem

    I have a system with two circuits operated via two 2 port Lifestyle valves. The main house circuit works fine via a separate Hive thermostat, the second circuit was an annex with another valve operated via another Hive thermostat. I noticed the boiler didn't always start when the annex heating...
  8. R

    Concealed Geberit Leak

    Thanks for the reply Olaf, I have spoken to Geberit technical support and the notches at bottom of basket do nothing, I have done all that you mention, leak seems to be coming from below black doughnut seal somehow, have sent photos to Geberit tech dept, hoping to get help.
  9. R

    Concealed Geberit Leak

    I have a problem with a very small trickle running into pan, I have replaced the inlet washer and checked water level, no difference. I have then replaced the valve washer as mention by lots on different forums but no difference. The only bit left is the large black basket washer, however I...
  10. R

    Honeywell CMT921 Operation?

    Thanks for the reassurance, so may not be a duff one after all, will see how it goes for a while, I do have an nPower service contract but wasn't sure what type of wireless thermostats they fit and found this one on Ebay. So fingers crossed it may be okay...
  11. R

    Honeywell CMT921 Operation?

    Ah, thanks Boilerman2, so it is in effect a sort of lag otherwise would be switching boiler on/off all the time, didn't notice it with the BG wireless one though, perhaps the Honeywell one is a bit more intelligent...
  12. R

    Honeywell CMT921 Operation?

    I have just bought a Honeywell CMT921 wireless thermostat on Ebay. I have just installed it in place of my BG one which was intermittently failing to switch motorized valve even though green receiver light was on. My question is, there seems to be a lot of "tolerance" as to when the...
  13. R

    Which Castle Alarm Panel

    I am considering replacing my old Chubb Windsor Alarm panel that I installed about 18 years ago with a Castle Castle Euro Mini Prox or Euro 46 Panel. I am hoping there are some Castle users/installers here that can help... My requirements are as follows:- 10 Zones minimum 3 Keypads Option...
  14. R

    Replace Garden Bench slats

    Gosh, I thought this thread was dead long ago.... :) The size of each slat on my benches is two and a half inches wide, three quarters of an inch thick and are 4' 8" long as I cut a couple of inches off each end, so was about 5' long originally, and there are 12 slats to each bench. It...
  15. R

    Two toilets on same soil pipe problem

    :lol: :shock: :wink: Guess I will have to see what my plumber has to suggest, thanks to everyone for your input........
Top