Hello
Looking for some guidance on type and installation of lintel.
Property is a two storey house with cavity walls each 100mm thick built from hollow concrete blocks with rendered finish. Roof is pitched with slates and truss system.
I am planning to install a new window in the first...
T
The existing wc is 2.2m from the stack. It is connected via a boxed in soil pipe branch which runs under the bath. The new wc will be around 3.6 m from the stack (the other side of an internal wall but against the same external wall).
I was thinking of doing the break in at ceiling height...
I’m planning to remodel my bathroom and fit an en-suite in the adjoining bedroom.
The soil stack currently runs internally down the inside corner of the house in the bathroom upstairs and cloakroom toilet downstairs.
I’d like to avoid running waste for the new en suite internally if possible...
@Exedon I don’t disagree with your assessment of plumbers skills but there are very few plumbers in my area and even fewer with G3 cert and willingness to quote. So I’m trying to work with what I’ve got!
@Exedon the hot water vented cylinder therefore unsealed and fed by a header tank in the loft. The central heating is also vented with an f&e tank in loft. I would be retaining the unvented central heating system. How would you propose to deal with decommissioning the vented cylinder flow and...
Yes the adjoining property has had a similar sized extension in the past so I am reasonably confident of obtaining planning permission. I’m sure it will be easier to get a quote once I have architects plans and pp but I would like to understand budget cost before purchasing.
Hi All
I'm looking at purchasing a property in NW England which will require extending to meet our requirements. It is on a great plot / location so we are keen to progress but trying to understand what a budget cost for the works might look like. Not had much luck in finding a local builder...
Hi all
I’m about to embark on a fairly large remodel of my back garden. Two areas of patio around 60 m2 in total with a clay paver path linking the two.
I’m using Baksteen pavers for the path and also as an edging around the patio. I’m going to lay two courses of them in a brick bond. I was...
New frame finally arrived. Came with some circular wooden beading in six sections. The old window was externally beaded but I am considering if it would better to install the new one with internal bearing - more weatherproof. What is the done thing with these?
Yeah I think I knew deep down 3 would be a bodge. I think I’ll go for 2 and shop around to see if I can get a new unit any cheaper.
I was planning on repainting the old frame but if I’m putting in a new one in oak I’ll varnish.
I’ll post a photo when it’s done!
Hi Ken
Unfortunately the oak frame price is supply only. I was planning on attempting to fit myself: wedge in place, then foam round the edge. Perhaps some stainless screws if I can hide them and get a decent fixing into the brickwork.
I’m a reasonably competent DIYer though I must admit to...