Recent content by RJRock

This worked a treat- after charging the old battery it’s continued to stay live. As I bought 2 20,000 mAh power banks it’s an easy swap and I’m guessing it’ll last for weeks

Awsome

Thanks that’s really good to know

Battery/ power bank for USB sensor activated light Looking for a power bank of at least 10,000 mAh with no auto off function. 5v 1a output. Problem: We have a lovely sink with a movement sensor that lights up the bathroom. It’s great for night time visits to bathroom and looks great. The...

It turns out the parts are available at £15 a set. [email protected]

The pictures show the plastic clip circled in yellow that has broken after just over a year of use. (The door therefore does not clip in and sags open). Elegant - the manufacturer- say they do not provide parts which is puzzling as they provide all the parts for the overall product. The broken...

Some advice please. I have a damp/ wet wall which is what would be the outside wall of a cavity wall 60’s house. The damp / wet bit is and always has been covered / inside an ‘outhouse.’ The problem has been gradually getting worse over the last few years. There is no issue inside the house/...

Just realised if Grippit blue ok for PB then as it needs a 25 mil hole to insert and activate the 'wings' surely that would work with pb backed with insulation? I've got an offcut to see if the insulation gives and allows the 'wings' to move into place.

Hi and thanks. When you say use metal wall rails to spread load, I assume you mean the 1 or 2 m metal rails (e.g from Screwfix). I was going to use those anyway (top and bottom of wall units), just a question of the way I'd fix the spreader rail to the PB. Would torx screws for brick wall...

72mm Insulated PB by RJRock posted 11 Dec 2020 at 8:51 AM Masonary Screw Torx by RJRock posted 11 Dec 2020 at 8:51 AM The PB is fixed to the insulation and insulation side dabbed to walls. Picture of torx screws - These would go through the PB/Insulation (72mm) air gap (25mm ish) and into...

Some advice please: I'm looking to fix kitchen wall units to (72mm total width) Plasterboard /Insulated backed Walls. The 72mm walls are dabbed to either lathe and ply walls (with air gap) or to Solid brick (not cavity) walls (with air gap). What is recommended: a hanging rail for both types...

need 5m sq of replacement boards 6 3/4 x 3/4 x ideally 3.5m lengths. Only thing is unsure if current boards are oak or pine. House build date is 1908. Any help appreciated or even if anyone has some boards available. Boards are not t and g. Pictures attached