Recent content by robflh

  1. R

    Gas Valve Settings

    I replaced the old twin entry rads with double panel double fin rads about three years ago. So hopefully there are no large deposits in them. Over the years the system has had X400 in it from time to time. Before I put a bottle of X100 and X200 in the system I want to give the whole system a...
  2. R

    Gas Valve Settings

    The Gas valve was re-adjusted last week and with the low set to 8.6 the boiler is working properly. Using the X800 for 8 hours or the X400 for a few weeks I will need to flush the system and get rid of any chemicals and sludge. My Baxi Platinum has a 22mm blanking plate underneath it for the...
  3. R

    Gas Valve Settings

    Never ever use it or use it for a few hours? My system only has six radiators and each of them is connected to a manifold with 8mm microbore. The manual for my boiler does not call it a system NTC. Page 8 item 25, page 57 section 12.10 and page 44 Wiring Diagram...
  4. R

    Gas Valve Settings

    Increasing or decreasing the CH temperature makes no difference; it still cycles but the hot water works fine at 55 degrees. I have some x800 but I would like to put that in the sysytem for a couple of weeks in a few months time. CH NTC is what he called it, which slightly confused me as it is...
  5. R

    Gas Valve Settings

    My Baxi Platinum 28 HE (47-075-21) has had the following fitted. Refurbished main heat exchanger, refurbished PCB, new electrodes and a second new gas valve. The boiler is back up and running but the gas goes off as it gets near the temperature the central heating has been set to and then the...
  6. R

    Gas Valve Settings

    My Baxi Platinum 28 HE (47-075-21) has had the following fitted. Refurbished main heat exchanger, refurbished PCB, new electrodes and a second new gas valve. The boiler is back up and running but the gas goes off as it gets near the temperature the central heating has been set to and then the...
  7. R

    Replacing a main heat exchanger on a Baxi Platinum.

    This forum does not support DIY gas work.
  8. R

    Internal Bathroom Wall is Not square.

    The internal wall at the none tap end of the bath is not at a right-angle to the side wall of the house. This results in a gap of about half an inch between the internal wall and the bath on the wall side of the bath. The gap gets smaller as you move along the internal wall and by the time you...
Back
Top