Our double patio/conservatory doors are jammed shut.
The lock has always been stiff and you could only really turn the key by pulling the doors towards you when on the inside, or by pushing into them when on the outside.
Now the key turns the same but the handle of the door with the lock...
Wires were in the heater. Water was also heating up - could feel through the glass. Terminals gave a reading of 30 ohms using meter.
Could it be the pressure switch?
Had flashing lights - top and also on/off.
Have replaced relays on pcb and connected all back together. Tried machine today and washed but would not go into final spin.
The water begins to drain out and the washing enhance light starts flashing. The water finishes draining but the lights...
Okay
Managed to replace relays on pcb and connected all back together. Tried machine today and washed but would not go into final spin.
Washing enhance light begins flashing, top light of five, as it should start spinning. Then continues like this for a bit with the only noise being the...
Okay - have managed to locate and remove screws.
There looks like there are a lot of connectors linking to the pcb housing (assuming that's what the white plastic is)
I'm also assuming I need to remove all of these?
So far have only managed to free the broadest one that clips directly...
Looking at rear of machine there is one screw at bottom left and a small rounded cover above with two screws fixing it in place.
Are the four screws you are talking referring to inside?
Thanks for all your help up to now
Measured with a meter getting a reading of about 31 ohms.
Is that too high? I know you said 25 ohms before
If not how do I sort out the relay on the pcb?
Not sure where exactly the pcb is and what I'm looking to replace