The lever on my UPVC door latch has broken.
Is it called anything other than a lever Latch?
I have googled lever Latch but unable to find anything similar.
Thanks in advance.
Hello good people,
I want to install an under stairs light. Can I use power from an existing 3 amp fused spur (which provides power to our alarm system)
It would just be a single gang light switch and ceiling rose.
Thankyou.
Thanks for the reply.
Took the programmer off and the backplate last night, checked all the wiring all tight and ok then turned off the heating and just left HW on timer.
Boiler hadn't fired up this morning but read another post on the web to tap the programmer and see if it fires up which I did...
Some help please.
I have a problem with my boiler firing up with a call for heat from the programmer.
Conventional boiler, potterton Promax HE with a UP2 British Gas programmer.
I noticed if the HW timer was on and not firing up if I scrolled through the Heating setting by pressing the select...
Hello everyone,
I need to reinstate the air bubble in the hot water tank and also reinstate the air pressure in my Expansion Vessel as I need to fit a new Schrader valve.
My question do I need to carry these two tasks in any particular order or does it not make any difference.
Thanks in advance
Hello everyone,
Bit of advice would be appreciated.
My Expansion vessel has recently been looked at by B Gas, the Engineer re inflated to 0.7bar via the Schrader valve and the water pressure was set at 1.2 bar.
This is because the water pressure kept on falling on the pressure gauge and I was...
That makes sense, thanks for the reply.
I was thinking about reducing the amount of PIR's I have, it would be easier to manage 4 than 8. Is it relatively easy to remove a PIR from the system.
I have the engineers code.
Thanks in advance.
Thanks for the reply, there has been a difference of opinion about this previously. I have the engineers code. The volume was set at 2 for the chime and the internal sounder anyway and it would wake the dead. I reduced it to 1 and it made no difference so I can only suggest the volume setting is...