By the way, Im asking as I had a job done for with weber, and they used metal beads
also the finish is rubbish, it looks as though its been...
Should you use metal beads on weber pral m rendering?
Also, if your not happy with the finish, can you lay another coat of pral M over the...
I'm having to lay some foundations for a single story extension I'm building. I will be building as close to a brick party wall as I can....
Thanks mate, will give it a go
Being a novice I will probably leave a fair bit of sand to do, any suggestions in the best sand paper to use?
I'm no expert, but you can get heat resistant plaster, not cheap, but designed for this situation.
I have a similar opening with equal power...
On dry wall?? I thought paper was best for this??
When your taping a tapered dry wall joint, do you embed the paper tape deep in to the joint, or just below the top surface??
Am I allowed to for the back boxes so I can connect the conduit to them.
If so, would metal back boxes be best secured to wooden bracing...
Yes I have taken in all the posts, and am looking at getting someone in, either to check the work I do or to do the work entirely
What would be the best compliant way of doing this??
Separate names with a comma.