Recent content by Rykard

They have this sort of thing on some car parks too...

small blade/ mallet managed to chip it off with no damage

sorted - thanks guys

Hi, not sure this is the right place, but none of the others seemed appropriate.. I have stuck a couple of hooks to a plastic window frame with some araldite. I now need to get the hooks off. Is there something that will 'neutralise ' the araldite and let me get them off? cheers Rich

Hi, my garden shed is in need of a spruce up. I have a couple of tins of decking oil. Will this be ok to use or do I need to consider something else? I presume using cheap rollers to put it on would be the way to go? cheers, Rich

after spending too much time and effort with the drill and driver on some small bits i decided to take the plunge and bought the erbauer yesterday, can't wait to get started with it. thanks for the help and advice.

thanks guys, i've watched a few vids and have decided to not buy an impact driver at the minute. I only have the one job, insulating the shed, atm so cannot really justify spending on one, after having bought a circular saw. I have two cordless drills, so i will drill pilot holes with one and...

Hi, i have to board my shed,19mm and 9mm plywood. I have been looking on utube and everyone seems to recommend an impact driver. Looking around they seem to be quite expensive. Are they worth the investment? Is there a good value recommendation? Cheers Rich

Another question, i will get this done at some point, how much space should i leave around the edges for expansion?

i was going to try to get the joists too, is this a problem?

Hi, I am looking to reinforce the floor of my shed as we're going to use it as a gym. I've ordered some 19mm ply, but need some advice on what screws to use to keep it flat. The shed floor is approx 1" thick. I've looked on screwf** but there are too many types, wood, timber, decking ??? help ...

Hi all, we are going to be taking delivery of a 12x8 wooden shed to use as a gym/garden room. I have a number of questions that I hope those with more knowledge than me can assist with. 1) Have been advised to paint it with oil based barn paint. Where do I get this from/ the mainstream stores...

is there a rule of thumb with regards to the extraction capability and the size of the room? (apologies for thread hijack)

i suppose then, considering the type of tasks i am doing, it may pay me to wait for aldi/lidl to do a li-ion drill/driver as like you say - keep the receipt and it should be fine..

at the minute i only plan on using a drill / driver. If i am going to be doing sawing I will go to a corded tool on the drive, rather than in situ. I am however mindful that if i buy right now, i will be able to extend in the future and with battery and motor technology advancing hand and fist...