Recent content by S_function

The board I want to remove/replace is short and at the end, which is convenient. I also have extra boards from when it was laid, so should be ok with the width. Have you experience with cutting out and replacing woodloc 5s boards? Are the replacement boards compromised at all? Do they ever come...

I have a Kahrs Woodloc 5s engineered wood floor, it's very good except in one location at the end, where it is a bit bouncy. I think the concrete base was not completely flat here and has a dip. I was thinking of cutting out a board, building up the subfloor, and replacing with a new...

Thanks for all your advice. As mentioned we have warm air central heating but it's not very good at heating the downstairs. It's an open plan house and the heat just rises upstairs. I thought getting additional underfloor heating would make the difference and mean downstairs would be much more...

The existing heating is warm air. And the existing hot water is from a storage heater. So i can't use them for the UFH.

Hi, thanks. Gas is in the house. I thought putting in a new gas boiler would be a bit tricky and costly. I assumed it would be a lot simpler to have an electric one. But if the cost would be huge then it may not be worth it. If the boiler is just used for the UFH, and considering the temp...

I want install underfloor heating (UFH) and, apparently, because of the wooden floor boards we can’t use an electric UFH system, so we have to use a water system. But I don’t have a gas boiler to make hot water. There are electric boilers which apparently- according to google- will be ok for...