Recent content by Salman007

Any suggestions and advice for painting the ceiling in attached picture. It’s old property, ceiling is not cement wall but has a plasterboard feel and sound to it when you knock it. I managed to remove wallpaper on it, you can see now it’s bare

I just applied a Two coat filler by hand as you can see, i will let it dry it overnight and apply sanding over it tomorrow then this part looks be ready to paint soon. Can you suggest what to do with the plasterboard wall that is the big wall in previous photos. Do I need to apply something or...

Few questions Can I use electric sander over the blue paste you see and also should I sand the ceiling or just paint it (already clean it) Also pls advice if I really need to plaster the walls, can I just use electric sander and filler to do job before painting Black marks on ceiling is the...

This is how it looks at present, forgot to mention that I clean all walls n ceiling with anti fungus spray. Don’t understand what you mean by mist coats, can u please shed some light on it Dulux super Matt was recommended by diy man to apply before normal Paint. Can someone tell me if new...

Now that I have removed wall paper I will take these steps, feel free to correct me and offer advice, much appreciated: 1. use quick dry filler (polycell)to fill any imperfections 2. Start using electric sandpaper on walls to smooth 3. Apply Dulux trade super Matt high opacity white paint 4...

I removed all wallpaper, have question as per photo how to seal these gaps between wall and ceiling wall

Ok I think I have done it. Today I opened the wiring junction board that the valve connects to as well as the programmer and found the Grey/Blue wire very loose in fact not making connection to it slot. I have photo attached, it's fourth set of wire from the right side. So after some fiddling...

Thanks, hope to do that tomorrow. Will update here.

Thank you. Final question should I open up the junction box and check for the orange wire ( which is the rightmost one, correct me if I am wrong) is the orange wire loose, fix it back and close the box. Offcourse with power supply off from the main.

Yes I have checked turning just hot water on (with heating off) does work because boiler is working (has a flame icon on display) and gas meter runs. But heating not come on it's own. Problem because every time I need heating I have to turn water on which means very hot water throughout day...

I don't know because a new valve was installed just six months ago, unless I suspect the internal wiring has come loose of the junction box, Or perhaps boiler need servicing which is covered by home service companies.

So what is needed, anything I can do to resolve this. I am considering signing up for home service like home serve or 247homerescue. Do you think they can come and bring it back to normal, I know they include boiler service because it has not been serviced since its brand new installation about...

No heating will not come when water is just on, I tried doing that with turning up the room thermostat to no avail.

Ok when turning hot water on by itself (without switching heating thermostat on) will start the boiler. Therefore now we know hot water does not need heating on to work but heating to switch on does need hot water on,

Actually I have to experiment with that (try that tomorrow) but definitely to get heating on I have to have hot water to on position.