Recent content by SAPFO

Any ideas why?

Actually I’ve just measured the joists they put in they are 1.5 x 3”

More

Agreed with the loft guys I wanted floor separated from the ceiling, and I also questioned the used of 4x2 when they came as I want the loft as a kind of light use cardio gym, rower, bike etc, not jumping around on a treadmill. So this is what they’ve done. Cross braced our 3x2 ceiling joists...

So it’s a simple job to DIY?

The boiler has thrown up F26 for a few years now, a simple reset & top up usually sorts it out, except now, after a long summer, it is being stubborn, and also showing up F03. We DO have hot water WE DON'T have heating Am I right in thinking the diverter value is knackered? I can source one...

Hi, we want to change our old thermo to enable us to control via Wi-Fi. Current one is an old analogue Honeywell with 2 wires, brown & blue. I see loads available on Amazon, but is there anything specific I’m looking for with just the 2 wires? Hopefully the pics are attached.

Hi, I was wondering if I can switch this for a more modern thermostat we can either time, or remotely control via wifi or whatever, without going whole hog. Just a simple upgrade on the current one where were nobody wants to leave their bed to turn the fecking thing on at 5am.

Thanks for the reply. It is a similar shower and the manufacturer recommends this as a replacement, along with someone here. I'm replacing a Gainsborough 8.5kw Style 400x, with a Gainsborough SE 8.5kw.

Before I hook this back up in just wanted to check where the spare earth goes. I know how to wire the 3 that are together, but where does the lone earth go ? I assume it is where the other earth goes right ? Thanks

Cheers. Do you know if this one has the same fittings?

Have and old electric shower. A Gainsborough Style 400x. As title says, I start it, it is hot for a split second, and then goes luke warm. Turning to the cold will make it go then usual cold. Tap hot water & CH fine Any ideas? Can I DIY it? Thanks