Recent content by ScubaCollie

Hi All, I've purchase 3 x pallets of Indian Sandstone and realised at the point of sale that they are for a square area, but thought it would be possible to create a double area with 2 x pallets by laying them side by side and then keep the 3rd one for spares in case I break them whilst laying...

S Trade Talk Patio Thread starterScubaCollie Start dateWednesday at 8:09 PM TagsNone Unwatch ••• S ScubaCollie Wednesday at 8:09 PM Add bookmark #1 Hi All, I'm removing decking that was installed when we purchased our house 4 years ago. We live in Scotland and one side was ramped...

Hi All, I'm removing decking that was installed when we purchased our house 4 years ago. We live in Scotland and one side was ramped to comply with DDA Regs, and the rear doors has a low threshold for wheelchair access. We haven't exactly decided what/how we are designing it yet, until it's...

Hi All, about to replace a tap, I've done a few in my time but never looked like this. Are these brass fittings push fittings? As they appear to go onto plastic fittings? How do I get them off? And how do I get a flexible hose nut type fitting back on to the water feed?

Many Thanks CBW and Madrab, really appreciate it. Would these two items be OK as they are telescopic to save me cutting? Or do I need that 90 degree you mentioned? And the below extension will fit inside that grey pipe piece inside the brown pipe? And then the pan connector will insert into...

Many Thanks Madrab, I've already tried pulling that piece of grey pipe out but it's wedged in their solid, don't know if they may have glued it. What are my other options? I need to extend that pipe up ideally by about 300mm, and will then be able to reach with a new flexible pan connector?

Or instead of the above I should be able to just use one of these? And reuse that white hose, the toilet end of that existing white hose is approx 100-110mm, therefore that should fit over the 97-107 inlet side of the below adaptor? And then I just fit the other end of that adapter to the toilet...

So I 'think' I may have solved it? Do I need to get a section of this, cut it down, insert this into the brown pipe in the wall, and then I can use the existing white hose to come off the new section of pipe...

I've unleashed a Monster! Tried to pull the white pipe up and it slipped out of the brown pipe, therefore would it be best to use rigid pipe into that main pipe and then connect up to a outlet flange onto the toilet? See photos below, the white pipe isn't going to reach the toilet as it's not...

I've managed to get the black elbow out ther wasn't difficult, and it measured as below. Bit concerned about disturbing that brown waste pipe as can't get hands down the side to steady it as too tight. Please see photos below for measurements of that white pipe, what options do I have if I...

If I pull that white pipe out can it dislodge the brown pipe further down inside the wall?

Photo

Thanks guys this is what's below it and will be difficult to reach down to the brown regid pipe and worried about disturbing it, if it comes out of something I'm stuffed..... THOMP1983, do I just pull that existing elbow out of that white section, then will measure, and then put a new elbow in...

Hi All, can anybody please help me out with toilet waste measurements and what sizes I need? I've ripped out an in-wall toilet as it's been nothing but agro since we moved in nearly 4 years ago, and I'm buying one of these...

Many Thanks therefore I did right by using PTFE tape on them?