Recent content by shad

sorry mate, i wouldn't know if they do that fitment as its the firt time i have purchased these. Any tips on what lubricant is good to use? SHAD

How much do you normally pay for them, do you think I got a fair price or was it too expensive. Thanks for the tip, I'll make sure I clean the pipe properly with a cloth. SHAD

I just purchased a 2 sets of speedfit flexi pipes. A 15mm set for the basin and a 22mm set for the bath. The basin set has isolator valve built in and it cost me £29. I think thats very expensive. After buying them, I've been checking the web and they seem a bit cheaper obviously. Anyone...

Thanks a lot guys, that answers the whole isolator and flexi pipe concerns I had. Thanks a lot to everyone that replied :D Kind regards SHAD

thanks Bahco, i suppose thats what I'll buy. But do you know how easy it is to fit the valve to the copper pipe. I know that the tap end just screws in, but how about the isolator end, how will it screw into the copper pipe. If anyone can help, then great. thanks again SHAD

HI, chaps, I'm about to fit a basin and bath tub and I'm not sure if I need to fit in an isolator value to each pipe(hot and cold). I know they are good for servicing but do i need them on the bath and basin. If so how do i get them on the copper pipes, how difficult is it to install...

Hi, I've done tiling a few times before, but I've never really known the best method to do this in. I normally start from one corner side but always worked from bottom upwards. The last time i did this, I had to cut the tiles that were right at the top as i went to the ceiling, this didn't...