Good Afternoon.
I am refurbishing 2 Chauvet Colour Bank 8 disco lights. These get very hot when in use as they use 8x 240v 50w JCDR Bulbs.
Is there any reason I can't replace them with an LED equivalent? I can't see an LED alternative as most MR16 are 12v. Would I be better changing them to...
Thanks. Is this not for inlet into 68mm rather than an outlet to 40mm or would it work the other way?
There is an adapter on there to 68mm. Not sure how clear it is in the picture.
I have had a good read through various posts which I found insightful and hopefully have helped me make my question clearer.
I am having work done on my property and need to amend the guttering on my small conservatory. The previous solution was drainage into a water butt that I no longer want...
Just to add. Flowchart states replace cabling and connections however I have fully tested the cabling with a multimeter and everything is fine. NTC is showing expected resistance when cold.
Boiler problem. Managed to get from an NTC fault but now have an APS fault.
So far boiler has new PCB, Fan, NTC sensor, Pressure Differential Switch and Air Pressure Switch.
Followed flow chart. PCB control outputs ok. Getting 22v from 8.3 - 8.5 but not getting 24v to Fan so fan isn't...