Recent content by shrimp

  1. S

    Gainsborough ambassador shower fluctuates in temperture

    I had thought it was the thermo cartridge but then she said it was ok with the heating on made me not so certain. Thanks for the links
  2. S

    Gainsborough ambassador shower fluctuates in temperture

    Someone must have some idea,I have searched the the forum and net but haven't found much. Cheers
  3. S

    Gainsborough ambassador shower fluctuates in temperture

    Hi there, She had a shower whilst the heating was on and she said the the temp stayed steady . So what could this be. Please help thanks
  4. S

    Gainsborough ambassador shower fluctuates in temperture

    Hi there, My mum is complaining her shower keeps on fluctuating between hot and cold when she has a shower. I have read that this could be down to the thermostatic controll valve is this true? The shower is feed by a combi boiler ? Could there be any other problem that could cause this...
  5. S

    Ducting extractor hood problem

    I have cut some of the floorboards out just above the hood and found there is and rsj in the way to go straight up,so I would need to cut the hole in the ceiling offset to the chimney . Also the boiler pipe goes 90 degrees to the left and they are right up against the floorboards so I am...
  6. S

    Ducting extractor hood problem

    Hi there, Would it be bad pratice and would it look crap,if I run the ducting without going into the ceiling cavaty space. I.e go from the chimney across above the cupboard and out through the wall by the boiler. Cheers dazz
  7. S

    Ducting extractor hood problem

    I take it you mean the 4th as in the one next to the window? If I set my circular saw to 18mm depth that should be fine and not hit any pipes hopefully lol Cheers
  8. S

    Ducting extractor hood problem

    Hi there , I fitted an extractor hood when I dine the kitchen and I used it in recirculating mode ,because of where the hood is situated. As you can see from the picture the extractor is turning the wall and ceiling black . Anyway I would like to duct the extractor to the outside,but the...
  9. S

    low level shower tray trap question

    hi there, I am in the process of sorting out my mums shower cubical and replacing the tiles for a showerwall paneling system ,anyway i done some research yesterday about shower trays just incase i had to remove the tray ,but i found that the waste trap should be easy to access ,but because my...
  10. S

    showerwall paneling

    cool the person that tiled the cubical made a crap job of it so i imagine it wont take much to get them off,but do you think it would be ok to use a sds drill with a chisel on it to remove the tiles or should i just use a bolster chisel. Thanks again
  11. S

    showerwall paneling

    hi there, I am looking at using showerwall paneling http://www.showerwall.co.uk/index.asp now this is going on a plasterboard walls in a shower cubical that already has tiles on it and i am wondering if i should take the tiles off, this is because i know there has been some water getting...
  12. S

    monobloc kitchen sink tap with filter tap dripping

    cool thanks for that i might have some tap washer some where. Just bloody gone a snap the single bolt thats made out of cheao copper need to extract that, also want to get some copper tails to help stop the tap working loose,do you know anywhere that sells them? Cheers for all the help :D
  13. S

    monobloc kitchen sink tap with filter tap dripping

    i cant remember who it was made by i shall have to find out but here is a pic of what inside Cheers
Top