Thanks gigz, do you think I should drain it completely or just enough to drop the pressure to 1.5-2?
Do you think this could help with the water not coming out hot from the taps?
Hi All,
My water from my combi boiler all of a sudden has gone from kicking out hot water to luke warm.
I checked the bolier and saw that the settings were all at the same level as they had always been set to but the pressure was up from 2 to 3 (when not firing).
I turned the system off...
Hi All,
I am fitting a glass based gas hob to a laminate worktop. With the hob there is a foam 2-sided sticky roll, however i would like to know if this is sufficient or if and what else I should seal it with eg a silicone sealer.
The last hob i installed ( a few years ago now), I used...
The switch looks like every other switch i have seen, so i don't think it has a terminal block in it. (just the two core connecting to the + - on the switch and the earth obviously on the case.
I will try and wire this up as you described with the extra block.
Thanks riveralt
Thanks guys,
I can sub the 3 terminal for a 4 terminal block I guess, it is just strange that the old light fitting that i have still, only has the same style 3 terminal block.
Do you know if this is a common occurance in flourescent light fittings?
Hi All,
I replacing my old fluorescent kitchen light with new one, however I can't work out the wiring for it.
In the light ceiling mount is a 3 screw terminal block (L,N,E) which connects to the Earth and ballast/tubes L and N terminals.
From the ceiling I have 3 sets of 2 core...