Hi
Anyone know a good way of cleaning the interceptor traps the u bends in sewer line with clay tea pot lid.
Mine is full of gravel that needs clearing.
I can't physically reach in and down so need to get debris out somehow .
Ideas ????
Thanks
Small cast iron rads to be fitted but existing pipework is 10mm fed from centre wall plate behind rad.
Any valves available to keep in line with the look of the rad? also need drainoffs as well.
Is this doable with speedfit pipe ?
Thanks
Thanks for the replys and debate . After all that's why we ask the questions.
I will go ahead with my original plan of 4 core 6mm because of load requirements for cabin. I know the armour can be used as earth but myself personally i always use a conductor and dont solely rely on the armours...
Hi
Tncs system
Log cabin 25m from house
See that when exporting earth 10mm earth is the prerequisite so would it be ok to use 4 core 6mm swa and double up 2 cores effectively making 12mm for earth.
And understand the need for non combustible in house ie metal consumer unit but how about...
Hi
Extension being built ground floor level.
King span insulation has been put down and floor will come up another 100m to finished level.
thinking of laying pipes in trunking on king span insulation .
What do people use for protection of pipes ie trunking and boxes to cover joints.
Where...
aaahh thanks for that explanation
i even get the positive applied bit with a large value resistor to pull the 12v high when negative removed (after researching it for so long) :shock:
so in my case to interface the risco agm dialer and galant panel
would the negative remove work...
Can someone please help me understand the terminology involved when triggering outputs
Driving me batty
i have a alarm panel with negative remove outputs on trigger header
i have a gsm dialler with negative remove inputs or positive remove inputs
selectable via a jumper
can these be...
thanksfor help sparky
got it working didnt relize its all deol and fire detector zone has to be deol as well
thanks
i want this circuit to connect to a risco agm universal gsm dialler
i didnt realize i got the stu trigger header as well
can i connect the trigger header outputs direct...
i get 12 v between trigger and 0v
but when i operate zone 5 the trigger doesnt change still stays 12v between 0v and trigger
if this was working as it should ..should the relay coil be between ov and trigger or 12v and trigger?
but trigger not changing state when i remove resistor...
can somebody please help me make sense of trigger outputs
been on it for hours cant seem to get it to work
trying to add a smoke alarm to ademco galant alarm panel
have programmed z5 as fire zone & programmed trigger output as fire (on pcb board says trigger n/c)
all i want to do is...
Hoover
Can you elaborate on that pls
I am planning to put both bellboxes in sab mode but supply the second bellbox with the secondary power supply
The triggers wont be affected will they?
hi
I also have an internal sounder
and because i have this new power supply and am not afraid to use it!
and if both bells can run sab mode i will.
how would i connect my new power supply so one bellbox runs off this new power supply??
thanks
hi
i originally did think that route
but bells output of panel is 500ma
and have read somewhere one texecom odyssey 3 bellbox pulls 500ma alone
and in scb mode 290ma
so with both running will be overloaded surely??