Recent content by sspaul121

Hi Dan, At this early stage I was looking at a very broad estimate. i.e 3-4k, 4-5k etc.....to the nearest thousand. I plan to get BG to do a survey once the main pipe work has been completed. Thanks, Paul

Hi all, Once our renovations are complete we have a 4 bed bungalow, with 2 en suite shower rooms and a family bathroom. We currently have a WB Greenstar 30CDi combi located in the middle of the bungalow. We plan to have the Combi removed and a 250lt/300lt UV Cylinder plus System...

Hi I noticed some brown spots on our ceiling during the recent heavy rains. On further inspection by a roofer, it seems the concrete tiles have come away from the bed of cement in 2 valley's. The 2x concrete valleys, and Concrete Ridge tiles are also on the way out too. Plus the cement has...

Hi Currenlty only getting luke Warm water from thermostatic mixer on bath. However all other taps including thermotatic mixers on other showers, taps in kitchen/batrooms are running hot water. I have even tried turning the flow down as I am aware that running the taps on full can impact...

No room for loft extension as roof space is only 4ft high. So probably no room for a HW cylinder. The funny thing is the loft still contains the old plastic water tank so this could be utilised for the supplying the HW cylinder as you guys have suggested. Slight saving there. The Combi...

Hi We are considering Solar power in the future hence the requirement of twin coil. I have also been advised that as the pump maybe in constant use the lifetime of it is normally 3-4 years and cost approx 300 for a resonable one. The other option I suppose is to install megalfo...

BG came in today. Flow rate 15 litres per min + 1 bar mains pressure.

Hi Currently planning to renovate family home. The current set up is 14 rads run off a WB combi Greenstar 30CDi. Mains Flow rate is 15 litres per min, which falls to 9 litres per min upon two taps being run. Mains pressure is approx 1 bar. Heating requirement for house is 18kw (I think)...

It varies on who I talk to re: Wet UFH. What would be the minimum set up requirements for WET UFH for a concrete floor. Insulation thickness, Pipe thickness?, Screed thickness? On top of this would be laid tile adhesive and 10-12mm porcelain flooring and 15mm engineered wood flooring.

Not sure about B&Q. Its funny Slough was mentioned as I was there last week for a wedding reception. In the afternoon I went to ee some bathrooms but there were few to choose from. I tried to go to Gibbs and Dandy but it was closed. Not sure if this was the place you were talking about.

Hi This would be to take chill of tiles. We were considering wet UFH but as all the flooring is concrete, the cost of hacking out concrete and then installing would be too expensive. Thanks Paul

Thanks. Aplogies for the dble post. The other post was to do with underfloor heating rather than porcelain tiles. Cheers, Paul

Hi Point taken regarding price and getting further quotations. I will get further quotes and plan accordingly. The boiler installation was to supply and fit. Cheers, Paul

Tried independent round the corner from where we live, but no joy. We do not want a detailed design just the basics i.e. what goes where and good suite and tile and lighting combinations for fairly dark rooms. Do you have details of the merchants please?

Hi Answers below: 2 ensuites + 1 family bathroom. 4 bedrooms eventually. You say its not a complete re-wire, what state is the house in? Paul - We could move in as is. Dated but does not need gutting just modernisation and change of layout. Will the sparky have to restore power or...