Recent content by steevieb

Thanks for the reply. I should have mentioned, the boiler is a Vaillant ecoTEC 832 H combi, all HW is controlled by that. There's 4 wires coming from the boiler to the current Nest heat link (and the earth is connected!)

Hello, I'm planning on adding a second zone to my CH, so I have upstairs and downstairs, both controlled by Nest thermostats. I already have the whole house on a Nest (located downstairs). I've access to the feed pipe, which goes into a T, one outlet serving upstairs and the other downstairs...

Hello, Our hall currently has wood floor over wooden floorboards. In winter, the floor is very cold and drafty. I shall fill around the edges to reduce the draftiness (there's a bit of a gap between the skirting board and bottom step and the floor...). We want to use vinyl planks as we're...

Thanks for clarifying! Yes, I would be removing the thermostat and relevant wiring and switching the NO1 and NO2 around (as NO1 is for heating and NO2 for water with this receiver). 1). Remove thermostat wiring. 2). Wire NO1 to terminal 5. 3). Wire NO2 to terminal 6. Fantastic, thanks...

Hello, I have a boiler and hot water tank in the S-Plan configuration, with a Potterton EP2000 and an old mechanical Honeywell thermostat. I want to replace the Potterton EP2000 and Honeywell thermostat with a newly purchased Heatmiser PRTHW-WTS Kit. Wiring in the receiver isn't the...

Images