Recent content by stevenmc2

sorry I'm lost? Cu red + other red into c ? then run a link from here accross into other bloc and into L1 with the other red? yes? thanks again

sounds good so far where should i run the reds to / from? cheers L1, L2, C.

I am trying to connect a 2 gang (2 independent lights) dimmer in my kitchen. The dimmer has 2 connector blocks- both with L1, L2, C. I have 3 sets of wires as follows: Wire A) Red, Black + Earth (From 1st Ceiling Light) Wire B) Red, Black + Earth (From 2nd Ceiling Light) Wire C)...

I've just added to 2 coats of Danish Oil to a wood table top. The oil has dried but is a bit rough to the touch in places. is this normal, should I give a light sand between coats? The top was dust free and I used lint free cloth to apply- so no problem there cheers

fire cement is so expensive

no came with nothing, just clips underneath

I'm just about to cut and fix my wall tiles above and around kitchen worktops. I have tiles and NOTHING else. What should I go shopping for? cutting, fixing, grouting etc. Tiles are 1. Glass Mosaic silver tiles and glass brick silver tiles. Also, not to sure how white grout will look/...

Do you seal a gas hob to worktop same as a sink/ I've been advised not to use sealent? I take it because the heat from hob will burn/melt seal or something?

so would you use the brass/copper olive on plastic pipe?

can you attach a compression flexi-hose (from kitchen mixer tap) to quick-fit plastic pipes or just copper?

yes! but I did'nt get a response! ____________________________ lynda, moderator please note forum rule 1a, I have now removed your other post of the same question

ok so far so good. Would appreciate some further advice. I need to connect flexi hoses from mixer tap to hot and cold water supply. From both cold and hot water supply pipes I have stop-cocks in place. I now need to connect a length of pipe from both stop-cock ends to flexi hoses...

chris that looks just the biz! I take it, the middle section of McAlpine is split inside pipe to avoid waste coming out one pipe and into the other?

thanks I need to fit both dishwasher and washing machine flexi drainage hoses into standpipe. Whats the best way of setting this up sorry your 1st link was not working

what do I connect end of waste pipes into? does anyone have a pic that shows what I need to buy to do this job? cheers