Search results

sorry I'm lost? Cu red + other red into c ? then run a link from here accross into other bloc and into L1 with the other red? yes? thanks again

sounds good so far where should i run the reds to / from? cheers L1, L2, C.

I am trying to connect a 2 gang (2 independent lights) dimmer in my kitchen. The dimmer has 2 connector blocks- both with L1, L2, C. I have 3 sets of wires as follows: Wire A) Red, Black + Earth (From 1st Ceiling Light) Wire B) Red, Black + Earth (From 2nd Ceiling Light) Wire C)...

I've just added to 2 coats of Danish Oil to a wood table top. The oil has dried but is a bit rough to the touch in places. is this normal, should I give a light sand between coats? The top was dust free and I used lint free cloth to apply- so no problem there cheers

fire cement is so expensive

no came with nothing, just clips underneath

I'm just about to cut and fix my wall tiles above and around kitchen worktops. I have tiles and NOTHING else. What should I go shopping for? cutting, fixing, grouting etc. Tiles are 1. Glass Mosaic silver tiles and glass brick silver tiles. Also, not to sure how white grout will look/...

Do you seal a gas hob to worktop same as a sink/ I've been advised not to use sealent? I take it because the heat from hob will burn/melt seal or something?

so would you use the brass/copper olive on plastic pipe?

can you attach a compression flexi-hose (from kitchen mixer tap) to quick-fit plastic pipes or just copper?

yes! but I did'nt get a response! ____________________________ lynda, moderator please note forum rule 1a, I have now removed your other post of the same question

ok so far so good. Would appreciate some further advice. I need to connect flexi hoses from mixer tap to hot and cold water supply. From both cold and hot water supply pipes I have stop-cocks in place. I now need to connect a length of pipe from both stop-cock ends to flexi hoses...

chris that looks just the biz! I take it, the middle section of McAlpine is split inside pipe to avoid waste coming out one pipe and into the other?

thanks I need to fit both dishwasher and washing machine flexi drainage hoses into standpipe. Whats the best way of setting this up sorry your 1st link was not working

what do I connect end of waste pipes into? does anyone have a pic that shows what I need to buy to do this job? cheers

scrit thanks! I dont have the foam backed strip you refer to, but there are clips, I'm presuming from your advice that this will sufice with some silicone cheers again

All good advice. What about putty or sealent though to fit sink down? I've seen glue for non-porous surfaces that also acts as a sealent- would this do the trick? cheers

What is the best for a secure tight and waterproof fitting? I'm ready to fit kitchen sink to worktop. Should I use epoxy (plumbers) putty or silicone sealent. I've heard that putty also come in rolls/strips, which sounds handy for this kind of job? Will sealent actually glue the sink to...

fraid not possible. As worktops have been cut by ikea (U shaped) and need then to fit 90% and flush against wall

Ok! all tips appreciated. i am fitting kitchen worktops but walls are not square (wavey). 2 choices as I see it 1. cut back of wortop to fit to wall 2. gouge chanel in wall to slot worktop into where wall sticks out. What do you reccomend? also if I go for option 1. whats the best way of...