Recent content by sunshinewelly

I have this switch at the moment - can i use one of these to hard wire the induction hob and new oven into the existing switch etc https://www.stevensonplumbing.co.uk/dual-cooker-cable-outlet-plate.html?srsltid=AfmBOop2NAzKiQVi6WIhFa2UXvWoOgd5Q4qaI-NoSdOJYC1toW7DkMU3

my ikea dishwasher has broken and i want to replace it with something else - ikea Uk say only ikea dishwashers can be used in metod cabinets. just wondering if this is correct and if not what others have used.

I had a kitchen refit 5 years ago and as part of the refit an electrician fitted the following Supply and Fit new mini consumer unit Installation of new kitchen ring (due to standard of existing electrics) Renew Earth bonding back to board Install new 6mm cooker circuit to induction hob at the...

https://www.bes.co.uk/radiator-tail-extension-1/2inch-x-30mm-long-25008/ Can i check this one is the same (albeit not as long etc)

cheers it looks as if the specs on the one i bought from tool station are incorrect as in the reviews it states it is a 3/4 union as you have noted

So here is right hand side and the connector works fine but that end used a 3/4 blanking cap whilst the radiator was off. The other end and the end i am struggling with fitted a 1/2 blanking cap. The extension piece end cap is slightly too big to screw onto valve end ( i have a blanking cap on...

Those seem the same dimensions as the 2 pack i bought but whilst it fitted right hand side of radiator the part that's screwed onto left hand valve is too wide. It's odd as a 1/2 blank cap does fit that end

https://www.ebay.co.uk/itm/143911992677?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=u8-mcmqbsx6&sssrc=4429486&ssuid=9-rjIOmBQd2&var=&widget_ver=artemis&media=WHATS_APP Will this work

I bought these last time but it's too big for the left side https://www.toolstation.com/made4trade-rigid-trv-extension-piece-12-x-15mm/p39383

Hi i was having my bathroom done and had the radiator taken off to be replaced with planned towel rail. Decided though to get new radiator instead. Now the old fitting was thrown out with the old radiator and I want to reconnect without having to drain system. I bought a set of connectors and...

ok cheers - i had no idea etc of pricing

I need some tiling done over my sink area - under the sill and to the left hand wall and to the right hand (there will be a unit covering the exposed boiler) and up to where the old tiles were (up to the paintw ork) how much would i expect to pay someone I have had a quote of £150 to fit...

cheers

I have had a kitchen fitted through Ikea and its been a bit of a disaster. the fitter is great but ikea have been crap in sending out the required parts. Anyway we now have a timing issue in so far as the fitter does not have time now to fit the wall panels which ikea have finally sent. the...

I am having a new kitchen fitted and also new LVT flooring. I currently have vinyl (sheet) flooring. That was fiited by a fitter and he screeded the concrete floor but did not do a great job as there are some patches where the vinyl shows 2 cm depressions underneath and on a couple of areas the...