Hi again
Finally managed to get drawer on. (With er indoors and son supporting)
I’ve reconnected the locking mechanism and poles. However, I think I inadvertently rotated one of the other adjusting screws, as frontal is now not flush with carcass. Do you know which adjusters I should use to...
Looking at the diagrams, the self locking bracket on the one side has just popped out of the drawer frontal. (loose screws?)
The drawer box would have been pushed into position on these brackets, so I just need to know how I pull the drawer off the brackets on the still connected side. I can...
Hi again
Not sure my last post made sense. I’m just struggling with design here.
1. The end of the bracket is screwed into door frontal and those screws have come out.
2. I can unsnap the bracket where it fits into “front of drawer tray”. (I think), but not sure how I would then get to the...
Thanks . Can see what you mean. So, with some pressure, I should be able to snap the whole thing off? What I don’t get is how that then enables me to reducer the bracket st the drawer frontal end.
I’m being really thick, so please humour me.
Hi
Thanks. Being really thick here. When you say remove drawer front, do you mean disconnect the one pole on the left hand side, and the pole and fixed bracket on the right hand side? I’m sure you’re right about screws, but don’t know how to access them to remove the bracket (side where still...
Update
Done some more checking. V evident that the side panel is connected to the drawer frontal damaged by two sharp spikes. It is these which have obviously detached over time. Does this suggest new drawer needed?
Ta
Thanks again. See what you mean with grey section of pole being in two parts etc. Have exposed top section as you can see from photo. However, the pole is correctly connected to the drawer. It is the section underneath that has slipped. (Exposing the screw hole in earlier photo) This is the...
Thanks for response. The drawer front is not fastened correctly on the left hand side. If you apply pressure, you can raise the drawer front up and down. More photos show the exposed screw holes, which I guess connect the runner to the drawer. front. Should there be bolts on that position...