Recent content by Teeny

Thanks for the info and I hope I don’t have the same problem as your dad. All I can do is wait and see now as it’s all fitted and the engineer has left.

When I rang up I was told that I had to have a smart meter. The chaps here at the moment and thankfully the alarm didn't go off when he turned the electric off. He just said that I could of had a replacement and didn't need to have the smart meter so i'm peed off about that. He did say that if...

The back up battery was replaced in March last year and its a y2.8-12. Im not very tech savvy the bell box has a strobe that's flashes when the alarm goes off. My meter has deemed dangerous so I've had no choice but to get it done. Thanks for the reply

Hi, I'm having a smart meter fitted today and I wondered if I need to do anything to my Veritas R8plus before they start doing it? Any advice would be gratefully appreciated. Thank you

Omg it’s sorted. Thank you so much for your help.

2,3,4,6,7,8

I put my 4 digit code in then press full

The Zones that it usually covers is 1,2 and 3. I’ve never really noticed what lights light up whilst it’s setting before but at the moment when I set the alarm only 1 and 5 flash until it sets. I don’t know if that will throw and light onto the situation. BTW thank you for the replies so far.

If I put the engineer code in then prog then 48 or 49 there are no lights lit

Do I need to be in the engineer mode then press 48?

Number 6

I just entered the engineer code, pressed prog, entered 116 then prog again but it still does the same. Am I doing something wrong?

I need to change it back so that when I enter zone 1 I can deactivate the alarm before it goes off

Hi, sorry my post was a bit manic, I went into panic mode after I messed the alarm up. My hallway is zone 1 and usually when I enter the hallway from either my front door or I come down from upstairs the 30 second delay tone sounds so I can get to the unit to turn the alarm off. Zone 1 doesn’t...

Can anyone help please. I’ve just replaced a battery in my alarm and I think I may have pressed some buttons that I shouldn’t of when trying to get out of the engineer section. When I do a full set now only lights 1 and 6 show when it’s setting. When I enter my hallway now it doesn’t beep like...