Recent content by tpaling

Thanks for your reply again, Can you recommend a clutch make or wbsite to buy one form. Obvioulsy, i will not be buying one untill it is stripped down to see if I need a flywheel or not. Thanks Tpaling

Thankyou for your prompt reply. Myself and my father will be replacing the clutch. My father has replaced clutches before, but this was a number of years ago, but he is willing and sees it as a challenge. Obviously, the key question is which clutch kit to buy, or do we strip it down first...

Hope someone can point me in the correct direction. I need to buy a clutch kit for a 2003 vauxall zafira 2.0dti. Am i correct in thinking that they can be brought as a 3 or 5 piece kit and if so what should i buy? Hope someone can provide some advice. Thanks T Paling

Thanks for your reply. There is no program button it is a knob that you turn to select the program. I can get out of the test sequence by tuning the machine off then on and pressing the start button quickly 4 times. I can then select a program and get the dishwasher to work. Sometime it...

Hi, Does anyone know the engineers test cycle for this model of dishwasher. The fault of not completing a program is now intermittant and on occasions the dishwasher completes a wash from start to finish. I can get into the engineers menu and run the test sequence/cycle and the machine...

Thanks for your response, removed pump today and tested with a multi-metre which indicated that there was not a full circuit. Replaced pump and all washers and gaskets relating to diverter value, expansion tank (which I re-pressurised) and the pump header and housing. Boiler fired up first...

Hi, I have the above boiler and last night i had loss of pressure due to a small leak from the pump unit. obviously, the boiler cut out due to lack of water pressure. The boiler has been making humming noise for a while now and i suspect that this is the pump. I mended the leak and left the...

Thanks for your reply again, Yes both PCB boards have same serial number. The CJ code was due to the dishwasher being in the Test mode. I have managed to reset the machine so normal programmes can be selected. However, the same or similar problem exists with both PCB boards. The cycle...

Thanks for your reply. I have just changed the PCB (old one form previous machine, same model) and the machine seems to have reset (i am able to select a programme). I have put the dishwasher on programme 3 and it started no problem and then cut out after a few minutes. But when I press...

Thanks for your reply, it is much appreciated. The dishwasher has been stopping mid cycle for a while now without showing any error codes, but would resume when the Start/Stop button is pressed in. On the rinse cycle (no heat required) the dishwasher went striaght through the programme, which...

Hope someone can help. My smeg dishwasher is displaying what looks like a CJ error code, which is not listed in the instruction manual.

I have the Smeg DWD1SSE-1 dishwasher and it works fine on rinse cycle, but on cycles that require heat it stops a number of times and after pressing and holding the start button it will continue to the end of the cycle. I think that it is possibly the heating element the door thermostat that...