Recent content by trap0001

I have a 14 month old Ariston A1637 that has the mains indicator LED plus three of the programme lights flashing. If I switch the mains of and on again it makes a buzzing sound. It won't do anything else it's just stck like this as though there is somekind of programme error perhaps. Can...

Whereas mine are blank! RS do a 48V Relay with this pin profile (10A contact rating), ref is 492-6754 and they cost £1.20+VAT each.

Thanks Tony, As an electronics engineer I could easily get my hands on a relay. The problem is almost sorted now, I have repaired the arced track (with a very thin strand of copper - this allows the track to fuse itself). Precautionery readings of all the other pcb components and the AP...

Close - there is a print burn out on PCB 2 (ignition sequence) on the NO leg of RELAY RL2 (which is wired around the fan and air pressure switch). Without a schematic it's not easy to establish exact cause of fault but I'm guessing arcing relay contacts has caused a conflict and lead to the...

Help! It's cold in here!!! :cry: Ideal Mini C28, when tap or heating started boiler fan starts up and immediately goes off and trys to re-start, doing this every second. No flame. No flashing error lamp (lamp states normal) Any ideas?

The +24V supply across the main res cap is clean. There is AC going getting to the relay coils. But there is an AC tap being fed into the main circuits so it is difficult without a schematic to establish where the bad AC is coming from.

Boiler won't start - relays all chatter like there's AC going through them - scoping relay coils reveals there is! 24V supply OK. Apparently this is a common Ferroli main pcb problem (which is actually manf by Honeywell). Anybody have any clues what this could be or perhaps a schematic for...

That's ok as long as the one you disconnected wasn't GREEN/YELLOW in which case... have you made provisions for your family in the event of your death.. or theirs?

Yeah well, I've just heard of a bloke putting his dog through a wash cycle to clean it. Dog died of course - he went to prison!!!!

My dishwasher won't wash. Flashes once and beeps. I am an electronics engineer but don't specialise in white goods so please excuse my ignorance in this department. :oops: Having found that my fault is a type F1 (NTC) and also having located the suspect part (feeler), I have metered it in...

It is the heating element as far as I know - but it is still sat there, ain't done it yet cos it will a pig to get out and strip down and we don't really need one. I'll get round to it one day!!!

My Prima LPR600 Dish Washer has the following fault. It starts up ok, pre-rinses for about 5 mins then goes in drain and beeps continuously, power lamps flashes twice constantly. Any ideas? :D The 12 digit numbers I found at the bottom are:- 8545 600 15810 33 0316 009315

Sounds like pump not turning - you may find that something has got stuck in the pump impellor, you'll have to remove pump (easy enough job) and check, if nothing and pumps spins freely change the pump motor.

WF440 will not spin, user has admitted overloading and machine 'thumped and banged' and then would not spin. When put in Spin Only program machine evacs and slowly turns but will not go into a fast spin. No error lamps.

3A fuse with 0.75-1.0mm flex will be fine.