Recent content by Tristar

  1. T

    What resin anchor?

    I’m about to fit a wall hung toilet frame. Any recommendations for the resin bolt anchors which are going into a 1970’s concert block wall?
  2. T

    Plumbing en-suite

    Thanks very much, unfortunately that is not possible, as when constructed in the ‘70s, the genius builder turned the soil pipe, against regs advice, through 90’ immediately below the existing connector before dropping to surface level. I am going back to the drawing board for a redesign, but...
  3. T

    Plumbing en-suite

    Apologies, I’m not great with uploading files. The existing bedroom and bathroom are adjoining. The bathroom WC drains into the soil stack which is in the corner of what will be the ensuite. To maximise the space in front of the new WC, because of the provision of a shower and WHB, I would like...
  4. T

    Plumbing en-suite

    To maximise the use of space available, I would like to fit the WC across the corner which means its outlet will be at 135dgs to the stack inlet of the WC in the bathroom next door. I cannot find a triple branch 135dg connector, is there a space saving way to connect to a 90 or 180dg connector...
  5. T

    Increasing aperture size in fixed worktop.

    Cancel all that. The hob has just arrived and has chamfered edges! So will not be recessed. I will have to build the front and rear steps up to support the front and rear edges of the hob. :(
  6. T

    Increasing aperture size in fixed worktop.

    Yes, I intended to do it in very small cuts 2 or 3 mil per pass, 15mm off each end. I am particularly concerned at getting the corners right, have been advised to use a straight flute. (n)
  7. T

    En-suite combination unit recommendations.

    Still an all in one, but I may have to go that route. Thanks for your help.
  8. T

    Increasing aperture size in fixed worktop.

    Thanks, I had in mind something like that. I am only a DIYer with a 1/4” router, any bit recommendations?
  9. T

    En-suite combination unit recommendations.

    Yes I saw that also, I can only think that was designed by a comedian.
  10. T

    Increasing aperture size in fixed worktop.

    I am replacing an inset hob with a slightly larger one. Any advice on using a router to increase the length of the aperture. It is not possible to get a standard jig in position or to remove the worktop without damaging it.
  11. T

    En-suite combination unit recommendations.

    Yes I had seen that one, but hardly any others. I’m not keen on moulded all in one tops and sinks, and prefer a separate sink and worktop.
  12. T

    En-suite combination unit recommendations.

    I am looking for a combination toilet and basin unit to fit in a new en-suite bathroom to be constructed. The unit will fit in the end of the suite such that the walls are flush with each end of the unit, which will be about 1100 -1200mm wide depending on unit availability. Unfortunately I can...
  13. T

    Flush fitting induction hob

    Good point about the warranty. IT doesn’t look naff IMHO having seen it done, and makes cleaning a doddle. Other makes allow it, so will go elsewhere This one was attractive due price and reviews. rgds
  14. T

    Village Hall Boiler

    You’d win the bet!
  15. T

    Flush fitting induction hob

    Thanks, looked at those before ringing AEG. As you can see it shows the hob sits on top of the worktop. I would like to know if there is any reason why it should not be inset flush with the worktop.
Back
Top