Looking to hardwire these contacts to enforcer v10 panel but unsure which colour wires to cut to get correct resistance of 6.9k total 4k7 alarm and 2k2 tamper
These contact will be wired to the two zones on the Panel...
Thanks do i need to change anything in the programming for the zones like the Resistors values or leave default settings
So make Zone 1 timed exit/entry and Zone 9 final set not timed as this is the door contact
Hi All
I currenlty have a old Euro Mini panel and looking to upgrade to the Euro-46 v10 so i can have a mixture of old wired PIR and new Wireless tech.
My question is looked in side the panel and the Zone wiring is different what the best way to install the old PIR back to the new panel the...
HI
Just installed a Euro46 panel with Digi WIFI/XA issue is i don't see this in programming or any light on the module my question does it just get recognised on power up or does it need to be enabled. or is it a fault unit any way of testing if power is getting to the unit with a Multi meter...