Please bare with me as without photo's this may be a bit difficult to describe.
Planning to decorate an attic room and make it feel as light and airy as possible.
The front wall of the room is vertical for 2 metres, then has about 3 foot of sloping (45 degrees?) to a beam.
The rear wall...
Hi, I have a slope on my attic floor either side of a brick supporting wall. Its an old conversion so the joists and as big as they shuld be, so the floor is a bit wonky. I've seen loads of terraced houses like this.
Anyway, I know I could use self levelling compound, but would laying sheets...
I need a door of none standard measurements. It needs to be 2040 * 675. I can get 2040 * 726. Can I get away with taking an inch of either side?
Many thanks
You put the foil nearest the surface that is losing heat, stopping heat loss through radiation. It will also double as a vapour barrier. Therefore it will be plaster, foil, blanket
I've been fitting plasterboard to some stud walls in my house. Its the first time I've done it and a couple of the screws near the edges / corners have crushed the plasterboard slightly.
Does it really matter?
Also there are some slight overlaps in a couple of places where bits of the...
Once my house gets warm the (combi C&M Britony combi SE)boiler seems to get lazy. It will turn itslef on every few minutes but a couple of hours after the house has warmed up it gets cooler but boiler doesn't seem to kick in again unless I turn the heat setting on the boiler all the way off and...