Recent content by willy6215

also no water coming out of valve where you pump ex vess

cheers for your reply. if i fill the system with water to 1 bar the needle goes to 1 bar i then turn the heating on but the needle does not rise but drops to zero in 20 to 30 mins. on zero again i have pumpd the ex vess so the gauge shows 1 bar. but the same happens no pressue rise but drops...

well when the boiler is on the needle dont go up just goes down from 1 bar ro zero in 20 mins. will i cause much damage running the boiler if there is a big hole in the ex vess?

cheers for the reply. when the boiler is on would i not get some kind of reading?

just put a digital pressure checker on my valve for ex vess and it reads 0.0. could it be that the ex vess has got a big hole in it?

hello help please i have a worcester combi si 2. i thought i had a slow leak on the expansion vessel pressure dropping slightly every 3 to 4 weeks. i wold top up the air a little and it would be fine. yesterday the pressue whilst the boiler was running dropped to zero very quickly. i pumped...

just to add. i have just had the internal vessel re-pressurised and its seems to be sticking at about nearly 3 bar, its not dropping suddenly when cold. is this a sign that the vessel is broken? i have experienced very high and low pressue which i have read are classic signs of it being broken.

just to add. i have just had the internal vessel re-pressurised and its seems to be sticking at about nearly 3 bar, its not dropping suddenly when cold. is this a sign that the vessel is broken? i have experienced very high and low pressue which i have read are classic signs of it being broken.

hello as the tile reads how much can i expect to pay. i have a worcester 28sii combi boiler and the vessel is knackered. its to much hassle to take the boiler off so i have been told i can have a external one fitted. thanks

hello i have a worcester combi boiler 28si. it as always dropped its pressure over time(last 3 years) 18 months ago i had some repairs by worcester bosch and he checked the ex vessel and he said it was holding its pressure ok he then re charged it. after that it would only go up by half a bar...

i have thougth a leak the upstairs seem ok no water coming through the ceilings. apart from trying to rip up the floor boards is there any way i can detect a leak with the down stairs rads???

hello i have read the pressure FAQ'S but i am looking for further advice. i have a worcester bosch combi boiler. last march i had pressure problems going really high then low. worcester came out and replaced the board? and a couple of things, they also re pressurised the expansion vessel...

folks thanks for your help. i have used raw plugs and its done the trick.

cheers jason they look good. do you know if there available from local stores like wilkos or B and Q? cheers

thank you for the prompt reply. i will try tomorrow, can i buy these bits i need from B and Q?