Hoping someone can advise.....
I had a garden wall built around 18 months ago and the front of the wall (from the top to the ground) was k-rendered. With the wall touching the ground, I find that when it rains, dirt from the ground splashes up on the wall.
I have attached a couple of photos of...
thanks @RandomGrinch and @ericmark
I was following the Tado instructions for replacing a Salus RT510 Receiver and it mentions to wire:
Green/yellow with brown sleeve to CH/ON terminal 4
Brown to L
Blue to N
Jumper setting to 2 (which is what I believe @ericmark suggests).
I have attached...
good morning @RandomGrinch , @CBW , and everyone else who may have looked at this post :giggle:. I have attached a photo of the wiring to the Salus Receiver. There is a link wire between L and COM. I also noticed the earth wire coming into the Salus Receiver has a brown sleeve on it just as it's...
thanks @RandomGrinch. If I ignore the extension kit, where do I wire the wires that are currently in the Salus RXRT510 receiver? This receiver is currently in the bedroom on the first floor where the boiler is located (boiler is inside a cupboard and the Salus receiver is just outside the...
as requested @RandomGrinch, I have attached photos of each of the two Tado Smart thermostats I have. I am 99% certain, both these thermostats were wired before the heating engineer removed them when the Heatmiser thermostats were installed. Each of these Tado smart thermostats also contain...
Thanks @RandomGrinch.
When I removed the Tado wired thermostat from my system, it was wired. Wouldn’t there need to be wiring to this thermostat at my son’s home?
Hoping someone can help. I used to have Tado fitted at home until I replaced this with Heatmiser due to introducing underfloor heating. The Tado equipment I have is the Internet bridge to connect to the router, a Tado Extension kit and a wired Smart Thermostat.
My son has recently moved into...
so I changed d.00 to 28kw. The speed of the boiler immediately increased and the modulation level went up to 4. I am now finding that the boiler flow temp is reaching the boiler target temp of 65C and the rads are heating up nicely.
Reading my IHD linked to my smart meter, I have found that I...
thanks @DP. What I am finding (and I noticed this, this morning) is that once the room stat setting has been reached, i.e. to 21.5C, the room stat sends a signal to the boiler to turn off. When the room temp drops down to 21C, it sends a demand to the boiler for heat. I noticed the boiler flow...
Thanks @Mottie. Do you recall what issue you had before you changed d.00 ?
Since my boiler is a 30kW boiler, I assume I would change d.00 to 30? What difference can I expect?
I recently had a new 2023 Vaillant ecoTec plus 630 (30kW) system boiler installed along with a Low Loss Header (LLH) in my house. I have 21 rads in the house and a room with UFH. The LLH was introduced as I was finding (before the LLH was fitted) that my old boiler (Vaillant heat-only boiler)...